Woodstock W1709 instruction manual Cleaning Belts, Servicing Separators

Page 29

After every 20-40 hours of use, lubricate the elevation screws, chains, sprockets, and the table guides under the table with a light coating of white lithium grease. See Figure 32.

Cleaning Belts

To increase working life of your sanding belts, we recommend that you routinely clean them with a Pro-Stik®Cleaning Pad shown in Figure 33.

To clean the belts, simply set your table to the thickness of the cleaning pad and run the pad through the sander two or three times. DO NOT take too deep of a cut. The belt should barely touch the cleaning pad!

Clean sanding belts whenever they decrease in performance due to heavy loading.

Servicing Separators

The moisture bowl on the regulator needs to be emptied and cleaned whenever it gets more than half full. See Figure 34.

Chain

Sprocket

Elevation

Screw

Figure 32. Lubrication points.

Figure 33. Pro Stik® cleaning pad.

Moisture

Bowl

Figure 34. Drain the moisture bowl often.

MAINTENANCE

-27-

Image 29
Contents Wide Belt Sander Page Contents About Your New Sander Woodstock Service and SupportIntroduction Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstStandard Safety Instructions Keep stable footing and balance at all times Additional Safety Instructions for Sanders Correct body and hand positioning Avoiding Potential Injuries220V Operation Electrical RequirementsExtension Cords GroundingUnpacking AssemblyBox Contents Shop Preparation Cleaning MachineSanding Belt Installation Air Hose InstallationDust collection adapters Dust CollectionPhoto-Electric Eye AdjustmentsGeneral Information Belt Tracking Belt tracking adjustment locationBelt Oscillation Speed Belt oscillation adjustmentTo adjust the belt tracking safety switches, do these steps Belt Tracking Safety SwitchPressure Rollers To adjust the pressure rollers, do these stepsTo tension the V-belts, do these steps Belt TensionFeed Belt Tension Tracking To adjust the feed belt tension and tracking, do these stepsDown Key Table Stop SwitchesTo adjust table stop switches, do these steps Control Panel OperationsTo complete the test run, do these steps Test RunSelecting Sandpaper To change the feed belt speed do these steps Setting Feed SpeedUsing the Load Meter Keypad and Display Emergency StopCalibrating the Table To apply the emergency stop, do these stepsTo sand a workpiece, do these steps Basic SandingQuick Tip Lubrication MaintenanceGeneral Servicing Separators Cleaning BeltsServicing Brake Brake assembly PadsFigures Changing V-BeltsSymptom Possible Cause HOW to Remedy TroubleshootingW1709 Wiring Diagram W1709 Control Panel Wiring Connections W1709 Switch Box Wiring Connections Parts Tool BOX Parts Elevation Screw Parts Conveyor Table Parts Piston Roller Shaft Parts Parts Parts Electrical Control BOX D3003 15 x 20 Cleaning Pad for Wide-Belt Sanders AccessoriesWarranty Card BOX BELLINGHAM, WA