Woodstock W1709 Table Stop Switches, To adjust table stop switches, do these steps, Down Key

Page 22

ADJUSTMENTS

Table Stop Switches

The table stop switches prevent the table lift motor from running the table into the sanding drum and bottoming out the table lift mechanism at the end of the jack screws. Periodically adjust the table stop switches.

To adjust table stop switches, do these steps:

1.Apply air to the sander and tension the sanding belt.

2.Push the down arrow key and lower the table until you achieve 6 inches between the sanding drum and the conveyor table surface. See Figure 22.

3.Loosen the mounting bolt for the table- down stop switch and move the switch so the switch plunger depresses against the stop block and you hear the switch click. See Figure 23.

4.Re-tighten the mounting bolt.

5.Push the up arrow key and raise the table until you achieve an 1⁄8 inch between the sanding drum and the conveyor table surface.

6.Loosen the mounting bolt for the table-up stop switch and move the switch so the switch plunger depresses against the stop block and you hear the switch click. See

Figure 23.

7.Re-tighten the mounting bolt.

8.Use the up and down buttons and test the

table operation and make sure the switches shut the table lift motor OFF when the table is at the minimum and maximum distance from the sanding drum.

Up and

Down

Key

Figure 22. Key pad table-lift controls.

Table Up	Mounting
Stop Switch	Bolt
Stop Block
	Switch
Table Down	Plungers
Stop Switch

Figure 23. Table stop switch adjustment

locations.

-20-

Image 22

Contents Wide Belt Sander Page Contents Introduction Woodstock Service and SupportAbout Your New Sander Warranty and Returns SpecificationsStandard Safety Instructions Safety FirstDisconnect machine when cleaning, adjusting or servicing Keep stable footing and balance at all times Additional Safety Instructions for Sanders Avoiding Potential Injuries Correct body and hand positioningExtension Cords Electrical Requirements220V Operation GroundingBox Contents AssemblyUnpacking Cleaning Machine Shop PreparationAir Hose Installation Sanding Belt InstallationDust Collection Dust collection adaptersGeneral Information AdjustmentsPhoto-Electric Eye Belt tracking adjustment location Belt TrackingBelt oscillation adjustment Belt Oscillation SpeedBelt Tracking Safety Switch To adjust the belt tracking safety switches, do these stepsTo adjust the pressure rollers, do these steps Pressure RollersBelt Tension To tension the V-belts, do these stepsTo adjust the feed belt tension and tracking, do these steps Feed Belt Tension TrackingTo adjust table stop switches, do these steps Table Stop SwitchesDown Key Operations Control PanelSelecting Sandpaper Test RunTo complete the test run, do these steps Using the Load Meter Setting Feed SpeedTo change the feed belt speed do these steps Calibrating the Table Emergency StopKeypad and Display To apply the emergency stop, do these stepsQuick Tip Basic SandingTo sand a workpiece, do these steps General MaintenanceLubrication Cleaning Belts Servicing SeparatorsBrake assembly Pads Servicing BrakeChanging V-Belts FiguresTroubleshooting Symptom Possible Cause HOW to RemedyW1709 Wiring Diagram W1709 Control Panel Wiring Connections W1709 Switch Box Wiring Connections Parts Tool BOX Parts Elevation Screw Parts Conveyor Table Parts Piston Roller Shaft Parts Parts Parts Electrical Control BOX Accessories D3003 15 x 20 Cleaning Pad for Wide-Belt SandersWarranty Card BOX BELLINGHAM, WA