![](/images/new-backgrounds/1222931/22293157x1.webp)
7-INSTALLATION
7.1 Operating Conditions
The machine should operate in a dry and relatively clean environment (See Specifications).
7.2Space Requirements for Machine Operation and Maintenance Work
Minimum distance from wall (Figure
A= 1000mm.
B= 700mm.
Minimum height = 2700mm.
Figure
7.3 Tool Kit Supplied with the Machine
A tool kit containing some tools are supplied with the machine. These tools should be adequate to
Figure
WARNING
•To reduce the risk associated with mechanical and electrical hazards:
−Allow only properly trained and
qualified personnel to operate and service this equipment.
WARNING
•To reduce the risk associated with muscle strain:
−Use the appropriate rigging and material handling equipment when lifting or repositioning this equipment.
−Use proper body mechanics when removing or installing taping heads that are moderately heavy or may be considered awkward to lift.
7.4Machine Set-Up / Bed Height
Adjust machine bed height. The case sealer is equipped with four (4) adjustable legs that are located at the corners of the machine frame. The legs can be adjusted to obtain different machine bed heights from 610mm [24 inches] minimum to 890mm [35 inches] maximum - See Specifications.
Refer to Figure
1.Raise and block up the machine frame to allow adequate leg adjustment.
2.Loosen, but do not remove, two (2) M8 x 16mm socket head screws in one leg (use M6 hex wrench). Adjust the leg length for the desired machine bed height. Retighten the two screws to secure the leg. Adjust all four (4) legs equally.
|
|
|
|
|
|
|
| M8 x 16mm |
| ||
|
| Socket Head |
| ||
|
| Screws |
| ||
|
|
| |||
|
| Adjustable |
| ||
|
| Leg |
| ||
|
|
|
|
|
|
|
|
|
| Figure |
|
|
|
|
|
|
|
17 |
|
| 2010 December | ||
|
|
|
|
|