
Adjustments (Continued)
WARNING
•To reduce the risk associated with shear, pinch, and entanglement hazards:
-Turn air and electrical supplies off associated equipment before perform- ing any adjustments, maintenance, or servicing the machine or taping heads.
-Never attempt to work on the taping head or load tape while the box drive system is running
Tape Leg Length
WARNING
•To reduce the risk associated with sharp blade hazards:
-Keep hands and fingers away from tape cutoff blades under orange blade guards. The blades are extremely sharp
Leading Tape Leg Length Adjustment – Figure 5-6
The
Moving this roller farther away from the box top or bottom surface will decrease the leading leg length. Moving it closer to the box top or bottom surface will increase the leading leg length.
Changing Tape Leg Length from 70 to 50mm
Note – When changing tape leg length, both upper and lower heads must be adjusted to apply the same leg lengths.
1. Remove and retain two hex head screws and remove the brush from normal position “A” on side frame.
2. Remount and secure brush in position
3. Remove
4. Remount
5. Remove and retain the
6. Remount tension roller assembly near top of slot
Tension
Roller
Tape Leg
50 or 70mm ± 6mm [2 or
Figure 5-6 – Leading Tape Leg Length
|
| |
Position A | Tension Roller | |
Assembly | ||
| ||
Position | Slot | |
| Slot C |
|
|
|
|
|
|
| Position B |
| |
Brush |
| Bracket | ||
|
| Position | Extension | |
|
|
7. Adjust tension roller according to "Leading Tape Leg Length Adjustment" above.
AccuGlide 3 Taping Head - 2"
16
Figure 5-7 – Changing Tape Leg Length
2009 February