Woodstock W1712 instruction manual Cabinet Assembly, To assemble the cabinet stand, do these steps

Page 13

Cabinet Assembly

TheModel W1712 mounts onto a heavy-duty formed sheet steel cabinet stand. Use the hardware in the cabinet hardware bag to com- plete this assembly.

To assemble the cabinet stand, do these steps:

1.Assemble the cabinet panels together as shown in Figure 4 with the supplied 5⁄16"- 18 x 3⁄4" hex bolts, 5⁄16" flat washers, 5⁄16" lock washers and 5⁄16" hex nuts.

2.Attach the remaining side panel.

3.Secure the rubber feet to the bottom cor- ners of the cabinet stand with the floor pad hardware bag as shown in Figure 5.

Mounting Locations	Side Panel
	Side Panel
	Front/Rear Panels

Figure 4. Cabinet assembly.

ASSEMBLY

Figure 5. Rubber feet installed.

-11-

Image 13

Contents Disc & 6 Belt Sander Page Contents Introduction Woodstock Service and SupportAbout Your New Sander Specifications Warranty and ReturnsStandard Safety Instructions Safety#16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Sander Extension Cords 110V OperationGrounding Unpacking AssemblyInventory Shop Preparation Initial CleaningDust Collection To assemble the cabinet stand, do these steps Cabinet AssemblyKeep the Sander Unplugged Mounting SanderInstalling table Installing TableBelt Tracking AdjustmentsTable tilting knob Scale Pointer Machinists Square Table Angle AdjustmentDisc Table Alignment Disc table adjustment bolts Only 2 of 4 shownTest Run OperationsBelt/Disc Selection Power SwitchMiter Sanding Flat Sanding Disc SandingCap screw location Work-Stop Fence Removing belt guard Table and Mounting Bracket Changing Sanding BeltChanging Sanding Disc Paper Sanding disc installationGeneral MaintenanceTable And Base Sanding SurfacesParts Parts Description Description Troubleshooting Sanding Parts Parts Warranty Card Woodstock INTERNATIONAL, INC