Table Angle
Adjustment
The scale pointers on the sander indicate the tilt angle of the sanding tables. The pointers have been set at the factory but throughout the life of your machine, you may need to adjust them.
To adjust the scale pointers, do these steps:
1.UNPLUG THE SANDER!
2.Loosen the table tilting lock knob shown in Figure 12 and rotate the table so it is per- pendicular with the edge of the sanding disc.
3.Place a machinist square on the disc sand- ing table and against the sanding disc to check for squareness (shown in Figure 13).
4.Lock the table tilt knob when the table is perpendicular to the disc.
5.Loosen the screw securing the pointer and adjust it so it indicates 90˚(Figure 13).
6.Repeat steps
UNPLUG the power cord when making any adjust- ments during operation! Otherwise, serious per- sonal injury to you or others may occur!
Tilting Knob