Woodstock W1712 instruction manual Cap screw location Work-Stop Fence

Page 22

To start flat sanding operations with the belt horizontal, do these steps:

1.UNPLUG THE SANDER!

2.Remove the belt sanding table.

3.Loosen the cap screw shown in FIgure 20 to allow the sanding belt to rotate.

4.Rotate the belt to the horizontal position then tighten the cap screw loosened in step 3.

5.Install the work-stop fence (shown in Figure 21) to prevent the workpiece from running off the end of the sander.

6.Start the sander.

7.Hold the workpiece firmly and in contact with the work-stop fence as shown in

Figure 22.

OPERATIONS

-20-

Cap Screw

Figure 20. Cap screw location.

Work-Stop Fence

Figure 21. Flat sanding operation.

Figure 22. Flat sanding operation.

Image 22

Contents Disc & 6 Belt Sander Page Contents Introduction Woodstock Service and SupportAbout Your New Sander Warranty and Returns SpecificationsSafety Standard Safety Instructions#16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Sander Extension Cords 110V OperationGrounding Unpacking AssemblyInventory Shop Preparation Initial CleaningDust Collection Cabinet Assembly To assemble the cabinet stand, do these stepsMounting Sander Keep the Sander UnpluggedInstalling Table Installing tableAdjustments Belt TrackingTable Angle Adjustment Table tilting knob Scale Pointer Machinists SquareDisc table adjustment bolts Only 2 of 4 shown Disc Table AlignmentOperations Test RunBelt/Disc Selection Power SwitchMiter Sanding Disc Sanding Flat SandingCap screw location Work-Stop Fence Changing Sanding Belt Removing belt guard Table and Mounting BracketSanding disc installation Changing Sanding Disc PaperTable And Base MaintenanceGeneral Sanding SurfacesParts Parts Description Description Troubleshooting Sanding Parts Parts Warranty Card Woodstock INTERNATIONAL, INC