Woodstock W1761/W1762 owner manual Auxiliary Fence, To build the auxiliary fence, do these steps

W1761/W1762 12" Table Saw with Riving Knife To build the resaw barrier, do these steps:

1. Cut two hardwood or plywood boards to 3⁄4" x 71⁄2" x 401⁄4" and 3⁄4" x 3" x 401⁄4". If you are using hard- wood, cut the boards oversize, then joint and plane the boards to the correct size to make sure the boards are square and flat.

Note: Only use furniture grade plywood or kiln dried hardwood to prevent warping.

2. Pre-drill and countersink 8 holes approximately 3⁄8" from the bottom of the 71⁄2" tall board.

3. Glue the end of the 3" board, then clamp the boards at a 90° angle with the larger board in the vertical position as shown in Figure 56.

Figure 56. Clamping the resawing barrier.

4.Secure the joint with 1⁄4-20 x 2" wood screws.

Auxiliary Fence

The auxiliary fence is necessary if you are resawing a workpiece that is taller than it is wide. It should be no less than 1⁄2" shorter than the board to be resawn.

To build the auxiliary fence, do these steps:

1.Cut a 3⁄4" thick hardwood or plywood board 401⁄4" long, and cut a height no less than 1⁄2" shorter than the board to be resawn. If you are using hardwood, cut the board oversize, then joint and plane the board to the correct size to make sure the board is square and flat.

Note: Only use furniture grade plywood or kiln dried hardwood to prevent warping.

2.Pre-drill and countersink four holes 11⁄4" from the bottom of the board.

3.Pull the end cap off of the standard fence, then remove four hex nuts, flat washers, hex bolts, and the fence facing on the blade side of the fence.

4.Thread the four M8-1.25 x 25 flat head screws through the auxiliary fence and into the hex nuts in the standard fence body, and tighten securely as shown in Figure 57.

	������
������	����
	����������
������
	�����

Figure 57. Auxiliary fence.

OPERATIONS

-39-