Woodstock W1715 manual Jklg

N(.(,Fne\ijDXelXcD]^%J`eZ\)&'/

J<KLG

-% On the other leg, insert the handle into the pre- drilled holes and secure it with the cotter pins (see =`^li\(').

K_\ YXe[jXn `j X _\Xmp dXZ_`e\ (++ cYj%  Lj\ Xjj`jkXeZ\ Xe[ jX]\ c`]k`e^& dfm`e^d\k_f[jn_\ec`]k`e^ k_`jdXZ_`e\%

.% With the help of an assistant, lift the bandsaw onto a pair of closely spaced sawhorses or other suitable support (see =`^li\(().

/% Attach the legs to the bandsaw with the M8-1.25 x 25 hex bolts, 8mm flat washers, and M8-1.25 hex nuts. Tighten them with a 14mm wrench or socket just enough to secure the parts. Final tightening will take place when the stand is fully assembled.

0% Remove the machine from the sawhorses, then install the tool tray in the middle of the stand with the M6-1 x 12 Phillips head screws, 6mm flat washers and M6-1 hex nuts, as shown in =`^li\().

('% Check to see if the bandsaw is relatively level, then final tighten all the nuts.

Cotter

Pin

=`^li\('% Handle installed with cotter

pins.

=`^li\((% Attaching leg assemblies.

=`^li\()% Installing tool tray.

-14-