Woodstock W1715 manual ik`ZXcFg\iXk`fe, Disconnect Bandsaw from Power

N(.(,Fne\ijDXelXcD]^%J`eZ\)&'/

M\ik`ZXcFg\iXk`fe

The Model W1715 can easily be set up for vertical cutting operations to make cuts that are not a straight cut through the entire workpiece, such as curves or pattern cuts.

KfXjj\dYc\k_\YXe[jXn]fim\ik`ZXcZlkk`e^#[fk_\j\ jk\gj1

(% DISCONNECT BANDSAW FROM POWER!

)% Remove the two flat head screws and the blade guide cover shown in =`^li\)*.

Blade

Guide

Cover

=`^li\)*% Blade guide cover.

FG<I8K@FEJ

*% Install the table and replace the two screws removed in Jk\g).

+% Install the table bracket with the pre-installed hex bolt, the M6-1 x 12 flat head screw, and the M6-1 hex nut, as shown in =`^li\)+.

,% Place a level on the table, as shown in =`^li\),, then use the adjustment bolt shown in =`^li\)- to make the table level.

Bolt Already

In Casting

=`^li\)+% Table and table bracket

installed.

=`^li\),% Adjusting table with a level.

Adjustment

Bolt

=`^li\)-%Table adjustment bolt.

-20-