N(.(,Fne\i jDXelXc D]^%J`eZ\)&'/
FG<I8K@FEJ
Lj`e^k_\M`j\
The vise is designed to secure the workpiece during horizontal cutting operations. Always use the vise when cutting with the bandsaw in the horizontal position.
KffcjE\\[\[ | Hkp |
Machinist's Square | 1 |
Kflj\k_\m`j\fepfliYXe[jXn#[fk_\j\jk\gj1 |
|
(% DISCONNECT BANDSAW FROM POWER! |
|
)% Check the vise with a machinist's square to make sure the vise is perpendicular to the blade and reads 0˚ on the scale as shown in =`^li\)0.
*% When the vise is square to the blade, place the material to be cut between the vise jaws.
+% Turn the vise crank handle (=`^li\ *') clockwise to firmly secure the workpiece in the vise jaws. The workpiece is now ready to cut.
:cXdg`e^8e^c\j
The vise can hold workpieces for angle cuts ranging from 0˚ to 60˚.
KffcjE\\[\[ | Hkp |
Wrench or Socket 14mm | 1 |
KfX[aljkk_\m`j\]fiXe^c\Zlkj#[fk_\j\jk\gj1 |
|
(% DISCONNECT BANDSAW FROM POWER! |
|
)% Loosen the hex bolts on the stationary vise jaw, as shown in=`^li\*(.
*% Rotate the sliding edge of the vise to the desired angle, indicated by the scale, and secure the bolts.
+% Place the workpiece between the jaws and clamp firmly.
Efk\1 K_\m`j\aXnfek_\c\X[jZi\ng`mfkj]i\\cpkf dXkZ_k_\Xe^c\f]k_\fk_\iaXn%
Scale
=`^li\)0% Using a machinist's square to adjust the vise perpendicular to the blade.
Vise Crank
Handle
=`^li\*'% Vise crank handle.
Hex Bolts
=`^li\*(% Loosening vise hex bolts.