RIDGID MS1250LZ1 Table Extension, Dust Guide, Extension Washer Socket Head Washer Screw Tighten

Page 15

ASSEMBLY

TABLE EXTENSION

See Figure 9.

The table extension can be used on the left side of the miter saw. To assemble and install the table extension:

Insert socket head screw and washer into the two holes in the side of the miter saw base.

Tighten securely.

MITER LOCK HANDLE

See Figure 10.

To install the miter lock handle, place the threaded stud on the end of the miter lock handle into the threaded hole in the control arm under miter table. Turn clockwise to tighten.

DUST GUIDE

See Figure 11.

Insert the dust guide inside the exhaust port in the upper blade guard. Turn the guide so that the open end is facing down or toward the rear of the saw.

TABLE

EXTENSION

WASHER

SOCKET HEAD WASHER

SCREW

Fig. 9

TIGHTEN

MITER
LOCK	TO
HANDLE	TO	CONTROL
HANDLE	LOOSEN
	LOOSEN
		ARM

Fig. 10

UPPER

BLADE GUARD

DUST

GUIDE

EXHAUST

PORT

Fig. 11

Image 15

Contents OPERATOR’S Manual Introduction Table of ContentsGeneral Safety Rules Read ALL Instructions Blade Coasts After Being Turned OFF  Before Making a CUT, be Sure ALL ADJUST- Ments are Secure Specific Safety RulesSpecific Safety Rules Symbol Name DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning ServiceElectrical Connection Cord Length Wire Size A.W.GElectrical Double InsulationGlossary of Terms Features Product SpecificationsMiter 12 IN. Blade Switch TriggerKnow Your Compound Miter SAW AMP Motor Tools Needed Loose Parts Dust Guide HEX BoltSocket Head Screws Washer Extention Dust BAG Blade Wrench Trace Holes AT These Locations For Hole Pattern SAW Base AssemblyUnpacking Mounting HolesUpper Blade Guard Dust Guide Exhaust Port Table ExtensionDust Guide Extension Washer Socket Head Washer Screw TightenSAW Dust BAGWork Clamp QuickTo Install Blade Screw Blade Bolt Cover Lower GuardLaser Guide Aligning the Laser Guide Line Mounting the Exactline Laser GuideBroken RED Line Cutting a Slot in the Zero Clearance Throat PlateSquaring the SAW Blade to the Fence See Figures 17Adjustments are Required Sliding Miter Fence Blade Combination Squaring the Blade to the Miter TableSee Figures 22 Lock KnobApplications Pivot Adjustments Travel Pivot AdjustmentBevel Pivot Adjustment OperationCutting with Your Compound Miter SAW To CrosscutStraight Crosscut Work Clamp See Figures 27 Bevel Scale IndicatorIndicator Point Screw Bevel CUT Work Clamp Stop PIN To Bevel CUTCompound Miter CUT Work Clamp To Compound Miter CUTLong Workpiece Supports Support Long WorkpiecesSee Figures 30 45 x 45 Compound Miter CUTCOMPOUND-ANGLE Settings for Popular Structures Cutting Compound MitersPitch Side Inside Corner Fence Cutting Crown MoldingLaying Molding Flat on the Miter Table CeilingSee Figures 34 Using a Crown Molding Support JIGMaking a Crown Molding Support JIG Cutting Warped MaterialLubrication MaintenanceGeneral Maintenance Clamping Wide WorkpiecesBrush CAP Brush ReplacementProceed as follows when replacement is required Brush AssemblyDo not attempt to activate the laser Changing the BatteriesHOW to Obtain Service What is not Covered WarrantyDAY Satisfaction Guarantee Policy What is Covered Under the 3 Year Limited Service WarrantyModel No MS1250LZ1 Serial No Customer Service Information