SMC Networks BLW-54MF Clients Computer Setup, Connect LAN Cables, Connect WAN Cable, Power On

3.Connect LAN Cables.

2Use standard LAN cables (RJ-45) to connect PCs to the switching hub ports on BLW-54MF. Both 10 Base-T and 100 Base-T connections can

be used simultaneously.

4.Connect WAN Cable.

Connect the DSL or Cable modem to the WAN port on BLW-54MF.

5.Power On.

Power the DSL or Cable modem on. At last, connect the adapter with BLW-54MF and plug the other side of the power cord into the power socket. Power BLW-54MF Wireless Router on. While detecting, the Power LED will be on and then the BLW-54MF will be ready in a short

time.

2. Client's Computer Setup

The computers on your LAN need to be set up to cooperate with BLW- 54MF Wireless Router.

Please make sure that your operating system already enabled your interface card on the host and connected to one of the LAN ports on BLW-54MF

through CAT-5 cable. Be sure that LEDs on BLW-54MF are already on and the LED corresponds with the port which you connected. If you switch on BLW-54MF for the first time, owing to the default status, it will

automatically enable the embedded DHCP server and start to distribute IP to your host. In addition, the default IP address of BLW-54MF is 192.168.1.1. If your operating system is Windows 98/2000/XP, you

may be able to use command of ipconfig to inquire whether you have

the correct IP address or not. If you are using Linux/Unix-Like system, you

can use	ifconfig	to check your NIC (Network Interface Card) address.
The instructions are as follows:
Windows98
1.Click	Start	Programs MS-DOS or Start RunĀ and type

in command.exe and then press enter.

8

BLW-54MF