AEG PV 2000 operating instructions

Page 19

19

Normal operation: When PV string DC voltage is greater than 150V, Protect PV operates in the normal state. In this state, it feeds power to the grid.

Protect PV automatically stops when the PV power is not enough.

a. Press the “Function” key repeatedly until “Contrast” shows in the display.

b. Hold the “Function” key down for more than 2 seconds, until display shows “Set contrast” and a bar graph on the right.

c. Press the “Function” key repeatedly until the display’s contrast is acceptable.

d. Release the key for more than 10 seconds, the display will show “Watt=xxxx.xW”.

Image 19
Contents DOC n 07/08/1002-2 Rev Protect pV 2000Contents BEFORe you start Risk of electric shock Safety instructionsTerms of warranty Limited warrantyWarranty claims procedure Exclusions Warranty extension Protect PV 2000 OverviewFeatures Before Installation Installation InstructionsMounting Protect PV to the wall Page Connecting to the grid AC utility Page Checking Connect to PV Panel DC inputSySTEm diagRam Modes of operation Operating Your PV-InverterFront Panel Page Accuracy of the readinG Maximum power point trackinG mpptDisplay information Inverter StatusERR Grid ERR Ground FaultOvertemperature ERR IsolationLCD Locked Model PVContrast SET ContrastCOmmuNiCaTiONS Page Display Trouble shootingLow DC Bus Modell SpecificationsDC Input Typical Efficiency charts vs. Load Incident Form Regulation & CertificatesCompliance & Standards Page Operating Instructions