AEG PV 2000 operating instructions

Page 13

13

6.Check the installation conditions

a)Do not install the PV- Inverter on a slanted surface

b)Check the upper straps of PV-Inverter and ensure it fits on to the bracket

c)Insert safety-lock screws to the bottom leg to secure the inverter.

Check the secure mounting of the PV-Inverter by trying to raise it from the bottom. The PV-Inverter should remain firmly attached. Select the installation location so that the status display can be easily viewed.

Choose a strong mounting wall to prevent vibrations while Protect PV is operating.

Image 13

Contents DOC n 07/08/1002-2 Rev Protect pV 2000Contents BEFORe you start Risk of electric shock Safety instructionsTerms of warranty Limited warrantyWarranty claims procedure Exclusions Warranty extension Protect PV 2000 OverviewFeatures Before Installation Installation InstructionsMounting Protect PV to the wall Page Connecting to the grid AC utility Page Checking Connect to PV Panel DC inputSySTEm diagRam Modes of operation Operating Your PV-InverterFront Panel Page Accuracy of the readinG Maximum power point trackinG mpptDisplay information Inverter StatusOvertemperature ERR Ground FaultERR Isolation ERR GridContrast Model PVSET Contrast LCD LockedCOmmuNiCaTiONS Page Display Trouble shootingLow DC Bus Modell SpecificationsDC Input Typical Efficiency charts vs. Load Incident Form Regulation & CertificatesCompliance & Standards Page Operating Instructions