Sterling A0544325 Routine Maintenance, Lubrication, Condenser Maintenance, Typical SMC Subpanel

Page 29

7

Routine Maintenance

 

 

7-1 Lubrication

Every three months, grease all fan motors and pump motors that do not have permanently sealed bearings. Remove grease relief plug (motors only) before adding grease. Failure to do so may result in dislodging the bearing grease retainer, eventually causing bearing failure.

Compressors are hermetically sealed; no oiling is required.

7-2 Condenser Maintenance

Dirty condenser heat exchange surfaces reduce system capacity.

Brush or vacuum light dirt accumulations. Avoid bending or damaging the fins. Heavy soil accumulations on the coil require professional steam cleaning; washing from the outside only makes matters worse.

Figure 14

Typical SMC Subpanel

Distribution

Block

Grounding

Lug

Terminal

Blocks

Control Voltage

Transformer

Pump

Condenser

Contactor

Contactor

SMC Series Chillers

Page 29

Image 29
Contents SMC-050 to SMC-150 Series SMC Series Chillers Safety Considerations Table of Contents Table of Contents Charts and Figures Introduction General InformationNecessary Documents Models CoveredUncrating Your New Chiller Available OptionsIf the Shipment is Incorrect Event of Shipping DamagesIf the Shipment is Not Complete SMC100A Process Pump Curves ReturnsSMC050A Process Pump Curves SMC150A Process Pump Curves SMC-150 25,400 16,000 12A 345 SMC Series Chiller SpecificationsProcess Water Connections Chiller InstallationElectrical Connections Water Reservoir SMC Condenser Air SupplyEthylene Glycol Curve Overhead Piping Overhead Process ConsiderationsRefrigeration Circuit Sequence of OperationChilled Water Circuit Remote Start/Stop Interlock High Pressure CutoutLow Pressure Cutout SMC Component Identification End of unit piping Piping Schematic 1 Pump with ReservoirPiping Schematic 1 Pump without Reservoir Piping Schematic No Pump, No Reservoir SMC Startup Checklist SMC Pre-Startup ChecklistSMC Water Circuit Pressure Drop Table Microprocessor Control Setting the Process Water TemperatureSetting the Alarm Value SP AL SMC ControlOptional Graphic Panel Indicator LightsSwitches Optional Graphic Panel SMC SeriesCondenser Maintenance Routine MaintenanceLubrication Typical SMC SubpanelTypical SMC Wiring Schematic SMC Wiring Schematic for Chillers with No Pump or Reservoir SMC Series Chillers Problem Possible cause Solution Troubleshooting GuideProblem Possible cause Solution Description SMC Spare Parts ListService Notes Service Notes 5200 West Clinton Avenue 414 Fax 414 Sterling/SterlcoMilwaukee, WI