Altinex PE1005 manual Mdon, Mdoff, 58. MD1, 59. MD0, Setmd, Settmd

SPECIAL APPLICATION

MOTION DETECTOR

MDON, MDOFF, MD1, MD0, SETMD RDMD

The next commands setup and control the motion detector. [SETMD] sets the trigger level and [MD0] and [MD1] assign subroutines to be executed depending on the direction of motion. [RDMD] displays the motion detector settings and [MDON] and [MDOFF] activate and deactivate the detector.

56.[MDON]

This command activates the external motion detector. The motion detector settings must first be defined using the [SETMD], [MD0] and [MD1] commands.

Command Format: [MDONCi]

Ci = Unit ID (i = # from 1 to 99)

Example:

Send the command [MDON] to activate/enable the motion detector.

57.[MDOFF]

This command is used to deactivate/disable the motion detector.

Command Format: [MDOFFCi]

Ci = Unit ID (i = # from 1 to 99)

Example:

Send the command [MDOFF] to disable the motion detector. None of the settings will be affected, but the motion detector will not be actively sensing for motion.

58.[MD1]

This command is used to assign a subroutine to be executed when an object is sensed moving toward the motion detector.

Command Format: [MD1=SUBkCi]

k = Subroutine (k = # from 1 to 99)

Ci = Unit ID (i = # from 1 to 99)

Example:

Assign subroutine 10 to be executed when an object is sensed moving toward the motion

detector by sending the command [MD1=SUB10].

59.[MD0]

This command assigns a subroutine to be executed when an object is sensed moving away from the motion detector.

Command Format: [MD0=SUBkCi]

k = Subroutine (k = # from 1 to 99)

Ci = Unit ID (i = # from 1 to 99)

Example:

Assign subroutine 11 to be executed when an object is sensed moving away from the motion

detector by sending the command [MD1=SUB11].

60.[SETMD]

This command sets the motion detector’s trigger level. The trigger level range is 0.1V to 5.0V and may be set in increments of 0.1V.

Command Format: [SETMD=xCi]

x = Trigger Level (x = # from 01 to 50)

01 = 0.1V

02 = 0.2V

…

50 = 5.0V

Ci = Unit ID (i = # from 1 to 99)

Example:

Set the trigger level a value of 1.0V by sending the command [SETMD=10]. Use the [RDMD] command to read values and check settings.

61.[SETTMD]

This command sets the motion detector’s time delay. The sensor will trigger until a target is found and then stop sensing and not check for a new target until after the specified delay time. The range is 01 to 99, where each increment is

0.1minutes and the minimum delay time is 6 seconds.

400-0384-003 24