Altinex PE1005 manual Mdtype, Rdmd, MD0=SUB10 MD1=SUB11, Rsi, SIDn

SPECIAL APPLICATION

Command Format: [SETMD=xCi]

x = Time Delay (x = # from 01 to 99)

01 = 0.1 minutes (6 sec)

02 = 0.2 minutes (12 sec)

…

99 = 9.9 minutes

Ci = Unit ID (i = # from 1 to 99)

Example:

Set the time delay to a value of one minute by sending the command [SETTMD=10]. Use the [RDMD] command to read values and check settings.

62.[MDTYPE]

This command sets the motion detector’s time delay. The sensor will trigger until a target is found and then stop sensing and not check for a new target until after the specified delay time. The range is 01 to 99, where each increment is

0.1minutes and the minimum delay time is 6 seconds.

Command Format: [MDTYPE=xCi]

x = Sensor Type (x = 0 or 1)

0 = Ultrasound Motion Detector

1 = PIR Motion Detector Ci = Unit ID (i = # from 1 to 99)

Example:

Set the time delay to a value of one minute by sending the command [SETTMD=10]. Use the [RDMD] command to read values and check settings.

63.[RDMD]

Use this command to display the motion detector’s settings and check its status. The status includes the settings, assigned subroutines, current detected reading, and whether or not the motion detector is active.

Command Format: [RDMDCi]

Ci = Unit ID (i = # from 1 to 99)

Example:

The motion detector’s trigger level is set to 1.0V. Subroutine 10 is assigned for objects moving away from the detector, and subroutine 11 is assigned for objects moving toward the detector. Send the command [RDMD] and receive feedback similar to the following:

Motion Detector ON

MD Current value:04

MD Threshold value:10

MD0=SUB10

MD1=SUB11

ID COMMANDS – RSI, SIDn, SIDnCi, RSN

64.[RSI]

This command resets the card IDs in the system. After sending this command, each card ID will be ‘0’.

Command Format: [RSI]

Example:

Send the command [RSI] to the system with ID 2. The card can no longer be recognized as ID 2, it will be ID 0.

REMEMBER: A command sent without the unit ID will be executed by all the PE1005s connected to the RS-232 port.

65.[SIDn]

This command sets the ID number of all cards connected to the RS-232 bus to the same value. The default unit ID is zero.

Command Format: [SIDn]

n= New ID (n = # from 1 to 99) Example:

Send the command [SID1] to the system. The card ID is now one, and “C1” must be included at the end of each command line, as in “[VERC1]”, for only the unit with ID1 to respond.

400-0384-003 25