Grizzly G0456 owner manual Set Up Safety, Items Needed for Set Up, Unpacking, Description Qty

Page 12

SECTION 3: SET UP

Set Up Safety

This machine presents serious injury hazards to untrained users. Read through this entire manu- al to become familiar with the controls and opera- tions before starting the machine!

Wear safety glasses dur- ing the entire set up pro- cess!

The Model G0456 is a heavy machine. DO NOT over-exert yourself while unpacking or moving your machine—get assis- tance.

Items Needed for

Set Up

The following items are needed to complete the set up process, but are not included with your machine:

Description		Qty
• Safety Glasses (for each person)		1
•	An Assistant	1
•	Forklift	1
• Lifting Straps (600 LB Minimum Rating) ....		2
•	Phillips Screwdriver #2	1
•	Hex Wrench 6mm	1
•	Wrench/Socket 13mm	1
•	Wrench/Socket 15mm	1

Unpacking

The Model G0456 was carefully packed when it left our warehouse. If you discover the machine is damaged after you have signed for delivery, please immediately call Customer Service at (570) 546-9663 for advice.

Save the containers and all packing materials for possible inspection by the carrier or its agent. Otherwise, filing a freight claim can be difficult.

When you are completely satisfied with the con- dition of your shipment, you should inventory the contents.

-10-	G0456 Variable Speed Wood Lathe

Image 12

Contents Model G0456 Variable Speed Wood Lathe Page Table of Contents Warranty and Returns Introduction ForewordContact Info Machine Data Sheet Identification Safety Safety Instructions for MachineryAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Wood Lathes 220V Single-Phase Circuit RequirementsSET UP Set Up SafetyItems Needed for Set Up UnpackingInventory Inventory Components Figure QtyHardware not shown Qty Clean Up Site ConsiderationsMounting Lathe Components and Hardware Needed QtyTo mount the lathe bed To install the sanding table To install the tool restSanding Table Tool RestDust Collection Test Run To connect a dust collection hoseTo test run the machine Operation Safety Safety Key OperationsControls Adjusting Tailstock Adjusting Tool Rest To position the tailstock along the bedTo position the tool rest along the bed Installing/Removing Spur Center To install the centersTo remove the spur center Installing/Removing Live Center To install the live centerTo remove the live center Selecting Turning Tools GougeTo set up a spindle turning operation Spindle TurningFaceplate Turning To mount your workpiece to the faceplateChanging Speeds Sanding/FinishingTo mount your workpiece to a backing block To change between High and Low speedsAttaching Sandpaper Disc SandingTo attach sandpaper To perform sanding operationsMiter Sanding Angle SandingTo perform miter sanding operations To perform angle sanding operationsAccessories G1194-3-Jaw ChuckG1082-4-Jaw Chuck G3168-1-1⁄2 x 8 TPI RH Threaded InsertModel H6542 Robert Sorby 8-PC Set G9863-8-PC HSS Lathe Chisel SetPSA Sanding Discs 2 pk Model GritH1300 H1298 G7984 H2347 H0736 Maintenance Cleaning/LubricatingService TroubleshootingWood Lathe Operation Tools Needed Qty To check headstock/tailstock alignmentTo align the headstock with the tailstock Replacing or Tightening V-Belt To change the V-beltReplacing Motor Brushes To replace the motor brushesTo adjust table tilt Table TiltAligning Table To align the tableTo adjust miter gauge Miter GaugeElectrical Components Wiring Diagram Parts Breakdown Parts List DescriptionDescription Warranty and Returns Page Page