Grizzly G0456 owner manual

Page 2

Safety labels warn about machine hazards and ways to prevent injury. The owner of this machine MUST maintain the original location and readability of the labels on the machine. If any label is removed or becomes unreadable, REPLACE that label before using the machine again. Contact Grizzly at (800) 523-4777 or www.grizzly.com to order new labels.

Image 2
Contents Model G0456 Variable Speed Wood Lathe Page Table of Contents Warranty and Returns Contact Info IntroductionForeword Machine Data Sheet Identification Safety Safety Instructions for MachineryAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Wood Lathes 220V Single-Phase Circuit RequirementsItems Needed for Set Up SET UPSet Up Safety UnpackingHardware not shown Qty InventoryInventory Components Figure Qty Clean Up Site ConsiderationsTo mount the lathe bed Mounting LatheComponents and Hardware Needed Qty Sanding Table To install the sanding tableTo install the tool rest Tool RestTo test run the machine Dust Collection Test RunTo connect a dust collection hose Controls Operation Safety Safety KeyOperations To position the tool rest along the bed Adjusting Tailstock Adjusting Tool RestTo position the tailstock along the bed To remove the spur center Installing/Removing Spur CenterTo install the centers To remove the live center Installing/Removing Live CenterTo install the live center Selecting Turning Tools GougeTo set up a spindle turning operation Spindle TurningFaceplate Turning To mount your workpiece to the faceplateTo mount your workpiece to a backing block Changing SpeedsSanding/Finishing To change between High and Low speedsTo attach sandpaper Attaching SandpaperDisc Sanding To perform sanding operationsTo perform miter sanding operations Miter SandingAngle Sanding To perform angle sanding operationsG1082-4-Jaw Chuck AccessoriesG1194-3-Jaw Chuck G3168-1-1⁄2 x 8 TPI RH Threaded InsertModel H6542 Robert Sorby 8-PC Set G9863-8-PC HSS Lathe Chisel SetH1300 H1298 G7984 H2347 H0736 PSA Sanding Discs 2 pkModel Grit Maintenance Cleaning/LubricatingService TroubleshootingWood Lathe Operation To align the headstock with the tailstock Tools Needed QtyTo check headstock/tailstock alignment Replacing or Tightening V-Belt To change the V-beltReplacing Motor Brushes To replace the motor brushesAligning Table To adjust table tiltTable Tilt To align the tableTo adjust miter gauge Miter GaugeElectrical Components Wiring Diagram Parts Breakdown Parts List DescriptionDescription Warranty and Returns Page Page