Grizzly G0456 owner manual Maintenance, Cleaning/Lubricating

Page 31

SECTION 6: MAINTENANCE

Always disconnect power to the machine before performing maintenance. Failure to do this may result in serious person- al injury.

G0456 Variable Speed Wood Lathe

Cleaning/Lubricating

Cleaning the Model G0456 is relatively easy. Vacuum excess wood chips and sawdust, and wipe off the remaining dust with a dry cloth. If any resin has built up, use a resin dissolving cleaner to remove it. Treat all unpainted cast iron and steel with a non-staining lubricant after cleaning.

Lubricate the unpainted cast iron surfaces on the bed by wiping the table clean after every use— this ensures moisture from wood dust does not remain on bare metal surfaces. We recommend using products such as G96® Gun Treatment, SLIPIT®, or Boeshield® T-9 for lubricating the unpainted cast iron on your machine.

-29-

Image 31

Contents Model G0456 Variable Speed Wood Lathe Page Table of Contents Warranty and Returns Foreword IntroductionContact Info Machine Data Sheet Identification Safety Instructions for Machinery SafetyAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Wood Lathes Circuit Requirements 220V Single-PhaseUnpacking SET UPSet Up Safety Items Needed for Set UpInventory Components Figure Qty InventoryHardware not shown Qty Site Considerations Clean UpComponents and Hardware Needed Qty Mounting LatheTo mount the lathe bed Tool Rest To install the sanding tableTo install the tool rest Sanding TableTo connect a dust collection hose Dust Collection Test RunTo test run the machine Operations Operation Safety Safety KeyControls To position the tailstock along the bed Adjusting Tailstock Adjusting Tool RestTo position the tool rest along the bed To install the centers Installing/Removing Spur CenterTo remove the spur center To install the live center Installing/Removing Live CenterTo remove the live center Gouge Selecting Turning ToolsSpindle Turning To set up a spindle turning operationTo mount your workpiece to the faceplate Faceplate TurningTo change between High and Low speeds Changing SpeedsSanding/Finishing To mount your workpiece to a backing blockTo perform sanding operations Attaching SandpaperDisc Sanding To attach sandpaperTo perform angle sanding operations Miter SandingAngle Sanding To perform miter sanding operationsG3168-1-1⁄2 x 8 TPI RH Threaded Insert AccessoriesG1194-3-Jaw Chuck G1082-4-Jaw ChuckG9863-8-PC HSS Lathe Chisel Set Model H6542 Robert Sorby 8-PC SetModel Grit PSA Sanding Discs 2 pkH1300 H1298 G7984 H2347 H0736 Cleaning/Lubricating MaintenanceTroubleshooting ServiceWood Lathe Operation To check headstock/tailstock alignment Tools Needed QtyTo align the headstock with the tailstock To change the V-belt Replacing or Tightening V-BeltTo replace the motor brushes Replacing Motor BrushesTo align the table To adjust table tiltTable Tilt Aligning TableMiter Gauge To adjust miter gaugeElectrical Components Wiring Diagram Parts Breakdown Description Parts ListDescription Warranty and Returns Page Page