Grizzly G0456 Sanding Table, Tool Rest, To install the sanding table, To install the tool rest

Page 16

Sanding Table

 

Components and Hardware Needed:

Qty

Sanding Table

1

Table Brackets

2

Dust Port

1

Lock Handles

2

Flat Washers 14" (Handles)

4

Cap Screws 516"-18 x 58" (Table)

2

Lock Nuts 516"-18 (Table)

2

Flat Washers 516" (Table)

2

Phillips Head Screws 10-24 x 12" (Dust Port) ...

2

Lock Washers #10 (Dust Port)

2

To install the sanding table:

 

1.Mount the dust port to the casting with the Phillips screws and lock washers.

2.Mount the table to the casting with the cap screws, flat washers, and lock nuts through the hinge hole; and with the lock handles and lock washers through the slotted hole. Figure 7 shows the table properly installed.

Figure 7. Table and dust port properly installed.

-14-

Tool Rest

 

Components and Hardware Needed:

Qty

Tool Rest

1

To install the tool rest:

 

1.Slide the tool rest shaft into the base, and tighten the lock handle. Figure 8 shows the tool rest properly installed in the base.

Lock Handle

Figure 8. Tool rest properly installed.

G0456 Variable Speed Wood Lathe

Image 16
Contents Model G0456 Variable Speed Wood Lathe Page Table of Contents Warranty and Returns Foreword IntroductionContact Info Machine Data Sheet Identification Safety Safety Instructions for MachineryAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Wood Lathes 220V Single-Phase Circuit RequirementsSET UP Set Up SafetyItems Needed for Set Up UnpackingInventory Components Figure Qty InventoryHardware not shown Qty Clean Up Site ConsiderationsComponents and Hardware Needed Qty Mounting LatheTo mount the lathe bed To install the sanding table To install the tool restSanding Table Tool RestTo connect a dust collection hose Dust Collection Test RunTo test run the machine Operations Operation Safety Safety KeyControls To position the tailstock along the bed Adjusting Tailstock Adjusting Tool RestTo position the tool rest along the bed To install the centers Installing/Removing Spur CenterTo remove the spur center To install the live center Installing/Removing Live CenterTo remove the live center Selecting Turning Tools GougeTo set up a spindle turning operation Spindle TurningFaceplate Turning To mount your workpiece to the faceplateChanging Speeds Sanding/FinishingTo mount your workpiece to a backing block To change between High and Low speedsAttaching Sandpaper Disc SandingTo attach sandpaper To perform sanding operationsMiter Sanding Angle SandingTo perform miter sanding operations To perform angle sanding operationsAccessories G1194-3-Jaw ChuckG1082-4-Jaw Chuck G3168-1-1⁄2 x 8 TPI RH Threaded InsertModel H6542 Robert Sorby 8-PC Set G9863-8-PC HSS Lathe Chisel SetModel Grit PSA Sanding Discs 2 pkH1300 H1298 G7984 H2347 H0736 Maintenance Cleaning/LubricatingService TroubleshootingWood Lathe Operation To check headstock/tailstock alignment Tools Needed QtyTo align the headstock with the tailstock Replacing or Tightening V-Belt To change the V-beltReplacing Motor Brushes To replace the motor brushesTo adjust table tilt Table TiltAligning Table To align the tableTo adjust miter gauge Miter GaugeElectrical Components Wiring Diagram Parts Breakdown Parts List DescriptionDescription Warranty and Returns Page Page