Delta 36-650 instruction manual Installing Switch Motor Cord, Recommended Motor for Your SAW

Page 10

INSTALLING SWITCH

AND MOTOR CORD

1.Insert switch cord (A) Fig. 13, and motor cord (B) of the switch assembly into the opening (C) under saw table as shown, and into the inside of the saw cabinet Fig. 14.

2.Insert switch cord (A) Fig. 14, and motor cord (B) into clamps (D) and loosely fasten both cords (A) and (B) Fig. 15, to the saw cabinet by turning screws (E) Fig. 14, clockwise. NOTE: Cords will be adjusted later. Place switch on top of the saw table at this time.

B

C

A

Fig. 13

B

C

A

D

E

Fig. 14

D

A

B

Fig. 15

RECOMMENDED MOTOR FOR YOUR SAW

The motor supplied with this machine has been specially selected to best supply power to your machine and the relative safety of the machine is enhanced by its use. We, therefore, strongly suggest that only this motor be used, as the use of other motors may be detrimental to the performance and safety of the saw.

10

Image 10
Contents Professional Table Saw Safety Guidelines / Definitions General Safety RulesAdditional Safety Rules for Table Saws Motor Specifications Power ConnectionsGrounding Instructions Unpacking and Cleaning Extension CordsProfessional Table SAW Parts Fence PartsStand Parts HardwareStand Legs AssemblyStand to SAW Blade Tilting and Raising Handwheel Installing Switch Motor Cord Recommended Motor for Your SAWMotor to Motor Mounting Plate Motor and Motor Mounting Plate to SAWMotor PULLEY, Pulley GUARD, and Drive Belt Connecting Motor Cord to Switch Assembly Illustrates the motor cord connected to the switch assemblyBlade Guard and Splitter Assembly Page Extension Wings Guide Rails Switch Assembly RIP Fence to Guide Rails Locking Switch OFF Position Operating Controls and AdjustmentsStarting Stopping SAW Raising and Lowering the Blade Tilting the BladeRIP Fence Operation and Adjustments Miter Gage Operation and Adjustment Changing the SAW Blade MaintenanceAdjusting Table Insert Overload ProtectionOperations CROSS-CUTTINGUsing Accessory Moulding Cutterhead RippingAlways Install Blade Guard After Operation is Compete Using Accessory Dado Head Using Auxiliary Wood Facing on RIP Fence Constructing a FeatherboardPushstick Constructing a Push StickAccessories PARTS, Service or Warranty AssistancePage Canadian PORTER-CABLE Delta Service Centers