Guide Rails Switch Assembly | Delta 36-650 specification

GUIDE RAILS AND

SWITCH ASSEMBLY

1. Loosely assemble front guide rail (A) Fig. 40, to the

front of the saw table. Align the two holes (B) and (C)

with the two holes in the saw table. Insert a 3/8-16x1-

1/2" flat head screw (F) Fig. 40, through holes (B) and (C)

in the front guide rail (A) and the holes in the front of the

saw table. Place hole in switch bracket (E) Fig. 40, on

screw (B) located behind the inner lip of the saw table.

Place a 3/8" flat washer (G) and a 3/8 lockwasher (H),

onto the flat head screw (F). Thread a 3/8-16 hex nut (J),

onto the flat head screw (F). Repeat this process for the

remaining hole (C) in the guide rail and the saw table.

2. Loosely fasten guide rail (A) Fig. 41, to the left and

right extension wings. Align the the hole (B) Fig. 41, in

the left side of the guide rail with the hole on the left

extension wing. Insert a 3/8-16x1-1/2" flat head screw

through the hole (B) in the front guide rail (A) and the hole

in the front of the left extension wing. Place a 3/8" flat

washer and a 3/8 lockwasher onto the flat head screw.

Thread a 3/8-16 hex nut onto the flat head screw.

Repeat this process for the remaining hole in the guide

rail and the right extension wing.

3. Before tightening the hardware holding the guide rail

to the saw table, proceed as follows: Beginning at the

two sides of the saw table and using an adjustable

square (F) Fig. 41, or a ruler, check to make certain the

guide rail (A) is parallel with the saw table and extension

wings. Tighten all guide rail mounting hardware.

4. Insert end cap (G) Fig. 42, onto each end of the

H FC

Fig. 40

Fig. 41

Fig. 42

guide rail (D) as shown. Using a block of wood and

hammer, gently tap end caps until they are completely

seated into each end of the guide rail. NOTE: Do not use

a hammer directly against the end caps, this could

cause damage to the aluminum rail.

5. Align holes in saw table and extension wings with

four holes in rear guide rail (J) Fig. 43. NOTE: Flat edge

of rear guide rail (J) will face upward. Insert a 3/8-16x1"

hex head screw (A) Fig. 43, through hole in rear guide rail

and hole in saw table. Place a 3/8" flat washer (B) Fig.

43, and a 3/8" lock washer (C), onto the hex head screw.

Thread a 3/8-16 hex nut (D), onto the hex head screw.

Repeat this process for the three remaining holes in the

rear guide rail and the saw table and extension wings.

6. Before tightening mounting hardware, using an

adjustable square (F) Fig. 44, or a ruler, check to make

certain the rear guide rail (J) is parallel with the saw table

and extension tables.

Fig. 43

Fig. 44