Delta 36-650 instruction manual RIP Fence to Guide Rails

Page 18

RIP FENCE TO GUIDE RAILS

1.Insert end cap (A) Fig. 45, into back of rip fence (B).

2.With the fence handle (A) Fig. 46, in the raised position, place the rip fence (B) onto the rear guide rail

(C) so the hooked end (D) Fig. 45, fits over the top ledge of the guide rail as shown.

3.Lower the front of rip fence (B) Fig. 46, onto the front guide rail (L).

4.Lock the rip fence (B) Fig. 46, on the guide rails by pushing down handle (A).

5.Slide rip fence (B) Fig. 46, against one edge of the miter gage slot (C) as shown. Clamp the fence onto the guide rail by pushing down on lock handle (A). The edge of the fence (B) Fig. 46, should line up so it is parallel with the edge of the miter gage slot. If an adjustment is necessary, tighten or loosen either of two screws (D) Fig. 47, as necessary until rip fence (B) Fig. 46, lines up with the miter gage slot. NOTE: Cursor has been removed for clarity.

6.Once the rip fence is aligned with the miter gage slot, raise the saw blade (E) Fig. 48, to its highest position, as shown. Slide rip fence (B) against the saw blade (E) and lock the fence in that position by pushing down on handle (A).

7.The cursor witness line (F) Fig. 49, should line up with the “zero” mark on scale (G). If the witness line does not line up with the “zero” line on the scale, loosen two screws (H) and adjust cursor (K).

B

A

D

C

Fig. 45

B

C

L

A

Fig. 46

D

D

Fig. 47

B

E

F

G

A

Fig. 48

K

H

Fig. 49

18

Image 18
Contents Professional Table Saw Safety Guidelines / Definitions General Safety RulesAdditional Safety Rules for Table Saws Power Connections Motor SpecificationsGrounding Instructions Unpacking and Cleaning Extension CordsProfessional Table SAW Parts Fence PartsStand Parts HardwareAssembly Stand LegsStand to SAW Blade Tilting and Raising Handwheel Installing Switch Motor Cord Recommended Motor for Your SAWMotor to Motor Mounting Plate Motor and Motor Mounting Plate to SAWMotor PULLEY, Pulley GUARD, and Drive Belt Connecting Motor Cord to Switch Assembly Illustrates the motor cord connected to the switch assemblyBlade Guard and Splitter Assembly Page Extension Wings Guide Rails Switch Assembly RIP Fence to Guide Rails Operating Controls and Adjustments Locking Switch OFF PositionStarting Stopping SAW Raising and Lowering the Blade Tilting the BladeRIP Fence Operation and Adjustments Miter Gage Operation and Adjustment Changing the SAW Blade MaintenanceAdjusting Table Insert Overload ProtectionOperations CROSS-CUTTINGUsing Accessory Moulding Cutterhead RippingAlways Install Blade Guard After Operation is Compete Using Accessory Dado Head Using Auxiliary Wood Facing on RIP Fence Constructing a FeatherboardPushstick Constructing a Push StickAccessories PARTS, Service or Warranty AssistancePage Canadian PORTER-CABLE Delta Service Centers