Delta 36-650 Motor to Motor Mounting Plate, Motor and Motor Mounting Plate to SAW

Page 11

MOTOR TO MOTOR

MOUNTING PLATE

DISCONNECT MACHINE FROM POWER

SOURCE.

Assemble motor (A) to motor mounting plate (B) as shown in Fig. 16. Align the four mounting holes in the motor with the four holes in the mounting plate. Insert a 5/16- 18x3/4" carriage bolt (C), through the hole in motor and then through the hole in the motor mounting plate, place a 5/16" flat washer (D) onto the carriage head bolt, place a 5/16" external tooth washer (E) onto the carriage head bolt, thread a 5/16-18 hex nut (F) onto the carriage head bolt. Repeat this process for the three remaining holes in the motor and the motor mounting plate.

NOTE: Do not completely tighten the hex nuts at this time.

MOTOR AND MOTOR MOUNTING PLATE TO SAW

DISCONNECT MACHINE FROM POWER

SOURCE.

1.Insert a pin (X) Fig. 17, into the holes in each side of bracket (B). NOTE: INSERT THE TAPERED END OF

PIN (X) FIG. 17, THROUGH THE INSIDE HOLE OF BRACKET (B).

2.Assemble spring (Y) Fig. 17, onto the non tapered end of each pin (X) as shown.

3.Position motor and motor mounting plate (A) Fig. 17, below bracket (B) to allow bracket arm to slide through large opening in motor mounting plate (A).

4.Depress pins (X) Fig. 18, on both sides of bracket (B) and rotate motor mounting plate (A) until pins (X) are engaged in holes (D) Fig. 17, of motor mounting plate

(A).

5.Fig. 19, illustrates the motor and motor mounting plate assembled to the rear of the saw.

B

A

C

D

 

E

F

 

Fig. 16

BX

Y

X

A

Fig. 17

X

B

X

A

Fig. 18

Fig. 19

11

Image 11
Contents Professional Table Saw General Safety Rules Safety Guidelines / DefinitionsAdditional Safety Rules for Table Saws Grounding Instructions Power ConnectionsMotor Specifications Extension Cords Unpacking and CleaningFence Parts Professional Table SAW PartsHardware Stand PartsStand to SAW AssemblyStand Legs Blade Tilting and Raising Handwheel Recommended Motor for Your SAW Installing Switch Motor CordMotor and Motor Mounting Plate to SAW Motor to Motor Mounting PlateMotor PULLEY, Pulley GUARD, and Drive Belt Illustrates the motor cord connected to the switch assembly Connecting Motor Cord to Switch AssemblyBlade Guard and Splitter Assembly Page Extension Wings Guide Rails Switch Assembly RIP Fence to Guide Rails Starting Stopping SAW Operating Controls and AdjustmentsLocking Switch OFF Position Tilting the Blade Raising and Lowering the BladeRIP Fence Operation and Adjustments Miter Gage Operation and Adjustment Overload Protection MaintenanceAdjusting Table Insert Changing the SAW BladeCROSS-CUTTING OperationsRipping Using Accessory Moulding CutterheadAlways Install Blade Guard After Operation is Compete Using Accessory Dado Head Constructing a Featherboard Using Auxiliary Wood Facing on RIP FenceConstructing a Push Stick PushstickPARTS, Service or Warranty Assistance AccessoriesPage Canadian PORTER-CABLE Delta Service Centers