Delta 36-650 instruction manual Pushstick, Constructing a Push Stick

Page 29

CONSTRUCTING A PUSH STICK

When ripping work less than 4 inches wide, a push stick should be used to complete the feed and could easily be made from scrap material by following the pattern shown.

PUSHSTICK

MAKEFROM1/2"OR3/4" WOODORTHICKNESS LESSTHANWIDTHOF MAT’L.TOBECUT

 

NOTCHTOHELP PREVENTHAND FROMSLIPPING

 

CUTOFFHERETO PUSH1/4"WOOD

CUTOFFHERETO PUSH1/2"WOOD

1/2"SQUARES

29

Image 29
Contents Professional Table Saw General Safety Rules Safety Guidelines / DefinitionsAdditional Safety Rules for Table Saws Grounding Instructions Power ConnectionsMotor Specifications Extension Cords Unpacking and CleaningFence Parts Professional Table SAW PartsHardware Stand PartsStand to SAW AssemblyStand Legs Blade Tilting and Raising Handwheel Recommended Motor for Your SAW Installing Switch Motor CordMotor and Motor Mounting Plate to SAW Motor to Motor Mounting PlateMotor PULLEY, Pulley GUARD, and Drive Belt Illustrates the motor cord connected to the switch assembly Connecting Motor Cord to Switch AssemblyBlade Guard and Splitter Assembly Page Extension Wings Guide Rails Switch Assembly RIP Fence to Guide Rails Starting Stopping SAW Operating Controls and AdjustmentsLocking Switch OFF Position Tilting the Blade Raising and Lowering the BladeRIP Fence Operation and Adjustments Miter Gage Operation and Adjustment Adjusting Table Insert MaintenanceChanging the SAW Blade Overload ProtectionCROSS-CUTTING OperationsRipping Using Accessory Moulding CutterheadAlways Install Blade Guard After Operation is Compete Using Accessory Dado Head Constructing a Featherboard Using Auxiliary Wood Facing on RIP FenceConstructing a Push Stick PushstickPARTS, Service or Warranty Assistance AccessoriesPage Canadian PORTER-CABLE Delta Service Centers