Delta 33-830 instruction manual

Page 7

COMPONENTS OF THE 10" PROFESSIONAL RADIAL ARM SAW

ILLUSTRATED IN FIGS. 4 AND 5

1.10″ Professional Radial Arm Saw

2.Left and right table supports

3.5/16-18 x 5/8″ Carriage Head Screws (16)

4.5/16″ Flat Washers (16)

5.5/16″ External Tooth Lockwashers (16)

6.5/16″ Hex Nuts (16)

7.Legs (4)

8.Front Table Board

9.Rear Table Board

10.Middle Table Board

11.Fence Board

12.1/4-20 Flange Nuts (4)

13.1/4-20 x 1″ Truss Head Screws (4)

14.Wrenches

15.1/4-20 x 1-1/4″ Pan Head Screws (4)

16.5/16-18 x 5/8″ Carriage Head Screws (6)

17.5/16″ Flange Nuts (6)

18.Wrench Hook

19.#10 x 1/2″ Screw (2)

20.Table Board Clamp Assembly (2)

1

7

2

6 4

5 3

Fig. 4

11

10

9

8

	17
20	19	18		12
	19	18	16
			16
				15
				13

14

Fig. 5

7

Image 7

Contents 10″ Professional Radial Arm Saw General Safety Rules Extension Cords Additional Safety Rules for Radial ARM SawsMotor Specifications Power ConnectionsGrounding Instructions Overload Protection Changing VoltageFunctional Description Unpacking and CleaningPage Explanation of Operating Controls Tools Needed for Assembly and Adjustment AssemblyAssembling Legs to SAW Base Removing Blade and Blade Guard from SAW Disconnect Tool from Power SourceAssembling Track ARM Clamp Lever Assembling Adjusting Table SupportsContacts the table board before the motor is fully Track ARM Clamp Handle Y are Assembling Table Board Clamps and Table Boards Adjusting and Checking SAW Blade Travel Square to FencePage Removing Heeling in SAW Blade CUT Checking and Adjusting SAW Blade Square To TableAdjusting IN/OUT RIP Scale Tongue on Guard Seats Into Groove of CUTTING-HEAD Assembling Blade and Blade Guard to MachineCutting Into Table Boards Fastening SAW to the FloorAdjusting Ball Bearings Against Track ON/OFF SwitchMotor Changing Position of Track ARM Clamping Handle Adjusting Tension on Elevating ColumnChanging Position of Yoke Clamp Handle Changing Position of Bevel Clamp HandlePositive Stop Yoke Index Adjusting Splitter and ANTI-KICKBACK FingersPositive Stop Bevel Index CROSS-CUT Stop Using a Table ExtensionAuxiliary Table Board Facing OperationsIN-RIPPING Compound Miter CuttingRipping OUT-RIPPINGConstructing a Push Stick PushstickTwo Year Limited Warranty PARTS, Service or Warranty AssistancePage Canadian PORTER-CABLE Delta Service Centers