Delta 33-830 Assembling Track ARM Clamp Lever, Assembling Adjusting Table Supports

ASSEMBLING TRACK ARM CLAMP LEVER

1.Assemble track arm clamp lever (A) Fig. 15, by threading into clamp lock nut (B).

ASSEMBLING

AND ADJUSTING

TABLE SUPPORTS

1.Place front table board (A) Fig. 16, on a stable surface with counterbored holes facing down, as shown.

2.Fasten left and right table supports (B) Fig. 16, to bottom of front table board (A) as shown, by inserting four 1/4-20 x 1″ long truss head screws (C) up through counterbored holes (D) in table board (A) and table supports (B). Secure in place using four flanged hex nuts

(E). Do not completely tighten nuts at this time.

3.Place front table board (A) Fig. 17, onto saw base (G), so that table supports (B) straddle the outside of saw base (G) and three holes (H) in each table support

(B) line up with three slots (J) in each side of saw base

(G) as shown.

4.Secure table supports, one of which is shown at

(B) Fig. 18, to each side of saw base using six 5/16-18 x 5/8″ long carriage head screws (K) and six flanged hex nuts (L). Do not completely tighten nuts at this time.

IMPORTANT: Insert screws through saw base table supports from the inside and place flanged nuts on screw on engaged side of base as shown.

B

A

Fig. 15

B

A D

C E

D

Fig. 16

A

H B

G

J

Fig. 17

B

L

K

Fig. 18

11