Delta 33-830 instruction manual

5.Loosen cutting-head clamp knob (S) Fig. 33, and slide cutting-head (T) the entire length of track arm (A) as shown to determine if blade (C) travels parallel to the square (E).

6.If an adjustment is necessary, loosen index ring locking screw (J) Fig. 34, and track arm clamp handle

(K).

7.Rotate track arm (A) Fig. 33, until blade (C) travels parallel to square (E). Then tighten track arm clamp handle (K) Fig. 34.

8.With track arm clamp handle (K) Fig. 35, tightened, rotate index ring (L) counterclockwise until it stops. Then tighten index ring locking screw (J) Fig. 36.

9.There are two miter index pointers, one of which is shown at (M) Fig. 36. Adjust as follows: loosen screw (N) and move pointer (M) until it lines up with the “zero” mark on the miter scale (P). Then tighten screw (N). Adjust the miter index pointer located on the other side of column (R) in the same manner.

A

S

C

T E

Fig. 33

J

K

Fig. 34

L

K

Fig. 35

J

N

MP

R

Fig. 36

15