Delta 33-830 Removing Blade and Blade Guard from SAW, Disconnect Tool from Power Source

Page 10

REMOVING BLADE AND BLADE GUARD FROM SAW

1.DISCONNECT TOOL FROM POWER SOURCE.

2.Loosen blade guard clamp knob (A) Fig. 11, and rotate blade guard (B) to the position shown.

3.With wrenches supplied (C) Fig. 12, loosen arbor nut

(D) as much as possible. NOTE: Arbor nut has left hand threads.

4.Lift cam (E) Fig. 13, which holds the blade guard (B) Fig. 12, in position and move the blade guard (B), outer blade flange (F), and blade (G) outward.

5.Lift blade guard (B) Fig. 14, and remove arbor nut (D), outer blade flange (F), and blade (G). Then remove blade guard (B).

A

B

Fig. 11

B

F

C

D G

Fig. 12

E

Fig. 13

B

G

F D

Fig. 14

10

Image 10

Contents 10″ Professional Radial Arm Saw General Safety Rules Additional Safety Rules for Radial ARM Saws Extension CordsMotor Specifications Power ConnectionsGrounding Instructions Changing Voltage Overload ProtectionUnpacking and Cleaning Functional DescriptionPage Explanation of Operating Controls Tools Needed for Assembly and Adjustment AssemblyAssembling Legs to SAW Base Disconnect Tool from Power Source Removing Blade and Blade Guard from SAWAssembling Adjusting Table Supports Assembling Track ARM Clamp LeverContacts the table board before the motor is fully Track ARM Clamp Handle Y are Adjusting and Checking SAW Blade Travel Square to Fence Assembling Table Board Clamps and Table BoardsPage Checking and Adjusting SAW Blade Square To Table Removing Heeling in SAW Blade CUTAdjusting IN/OUT RIP Scale Assembling Blade and Blade Guard to Machine Tongue on Guard Seats Into Groove of CUTTING-HEADFastening SAW to the Floor Cutting Into Table BoardsAdjusting Ball Bearings Against Track ON/OFF SwitchMotor Adjusting Tension on Elevating Column Changing Position of Track ARM Clamping HandleChanging Position of Bevel Clamp Handle Changing Position of Yoke Clamp HandlePositive Stop Yoke Index Adjusting Splitter and ANTI-KICKBACK FingersPositive Stop Bevel Index Operations Using a Table ExtensionAuxiliary Table Board Facing CROSS-CUT StopOUT-RIPPING Compound Miter CuttingRipping IN-RIPPINGPushstick Constructing a Push StickPARTS, Service or Warranty Assistance Two Year Limited WarrantyPage Canadian PORTER-CABLE Delta Service Centers