Delta 33-830 instruction manual Changing Voltage, Overload Protection

Page 5

GROUNDED OUTLET BOX

GROUNDING

MEANS

ADAPTER

Fig. C

CHANGING VOLTAGE

The motor supplied with your saw is wired for 120 volt operation. If you desire to operate your saw at 240 volts, it is necessary to reposition voltage changing switch in the motor junction box (B) Fig. E. Proceed as follows:

1. WARNING: DISCONNECT TOOL FROM POWER SOURCE.

2.Remove screw (A) Fig. E, and remove nameplate cover (B).

3.Carefully slide switch (C) Fig. F, in motor junction box to read 240. Replace nameplate cover and screw which were removed in STEP 2.

4.It is also necessary to replace the 120 volt plug supplied with the motor with a UL/CSA listed plug suitable for 240 volts and the rated current of the saw. Contact your local Authorized Delta Service Center or qualified electrician for proper procedures to install the plug. The saw must comply with all local and national electrical codes after the 240 volt plug is assembled.

OVERLOAD PROTECTION

The motor on your saw is equipped with a resettable overload relay button (D) Fig. G. If the motor shuts off or fails to start due to overloading, or low voltage, turn the switch to the “OFF” position, let the motor cool three to five minutes then push the reset button (D). The motor can then be turned on again in the usual manner. Some conditions that may cause overloading are; cutting stock too fast, using a dull blade, using the saw beyond its capacity, etc.

GROUNDED OUTLET BOX

CURRENT

CARRYING

PRONGS

GROUNDING BLADE

IS LONGEST OF THE 3 BLADES

Fig. D

BA

Fig. E

C

Fig. F

D

Fig. G

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents 10″ Professional Radial Arm Saw General Safety Rules Extension Cords Additional Safety Rules for Radial ARM SawsGrounding Instructions Power ConnectionsMotor Specifications Overload Protection Changing VoltageFunctional Description Unpacking and CleaningPage Explanation of Operating Controls Assembling Legs to SAW Base AssemblyTools Needed for Assembly and Adjustment Removing Blade and Blade Guard from SAW Disconnect Tool from Power SourceAssembling Track ARM Clamp Lever Assembling Adjusting Table SupportsContacts the table board before the motor is fully Track ARM Clamp Handle Y are Assembling Table Board Clamps and Table Boards Adjusting and Checking SAW Blade Travel Square to FencePage Removing Heeling in SAW Blade CUT Checking and Adjusting SAW Blade Square To TableAdjusting IN/OUT RIP Scale Tongue on Guard Seats Into Groove of CUTTING-HEAD Assembling Blade and Blade Guard to MachineCutting Into Table Boards Fastening SAW to the FloorMotor ON/OFF SwitchAdjusting Ball Bearings Against Track Changing Position of Track ARM Clamping Handle Adjusting Tension on Elevating ColumnChanging Position of Yoke Clamp Handle Changing Position of Bevel Clamp HandlePositive Stop Bevel Index Adjusting Splitter and ANTI-KICKBACK FingersPositive Stop Yoke Index Auxiliary Table Board Facing Using a Table ExtensionOperations CROSS-CUT StopRipping Compound Miter CuttingOUT-RIPPING IN-RIPPINGConstructing a Push Stick PushstickTwo Year Limited Warranty PARTS, Service or Warranty AssistancePage Canadian PORTER-CABLE Delta Service Centers
Top Page Image Contents