ASSEMBLING BLADE RAISING AND TILTING HANDWHEELS
1.Assemble the blade raising handwheel (A) Fig. 7, to the blade raising screw (B) making sure the slots (C) in the hub of the handwheel are engaged with the roll pins
(D) on the raising screw shaft.
2.Assemble flat washer (not shown), and lock knob (E) Fig. 8, on end of raising screw shaft.
3.Assemble tilting screw handwheel (F), flat washer (not shown), and lock knob (G) Fig. 8, to the blade tilting screw shaft in the same manner, as shown in Fig. 8.
ASSEMBLING
EXTENSION WINGS
1.Assemble extension wing (A) Fig. 9, to the saw table using the three 16MM screws, lockwashers, and flat washers (B). With a straight edge (C) Fig. 10, make sure the extension wing is level with the saw table before tightening the three screws (B) Fig. 9.
2.Assemble the other extension wing to the opposite end of the table in the same manner.
B
D
A
C
Fig. 7
E
F
G
Fig. 8
A
B
B
Fig. 9
D A
C
Fig. 10
10