ASSEMBLING SAW BLADE
1.Make certain the tool is disconnected from the power source.
2.Loosen two screws and remove the table insert (A) Fig. 11. IMPORTANT: Be careful not to lose two rubber washers (L) located under table insert (A).
3.Raise the saw blade arbor (B) Fig. 11, to its maximum height by turning the blade raising handwheel counterclockwise and remove the arbor nut (E) (turn clockwise) and outer flange (D) from the saw arbor.
4.Assemble the saw blade (C) to the saw arbor making sure the teeth of the blade point down at the front of the table, as shown in Fig. 12, and assemble the flange (D) and arbor nut (E) (turn counterclockwise) to the saw arbor and tighten arbor nut (E) as far as possible by hand, being sure that the saw blade is against the inner blade flange.
5.Using the open end wrench (F) Fig. 11 and Fig. 12, supplied, place the wrench (F) on the flats on the saw arbor to keep the arbor from turning and tighten arbor nut (E) (turn counterclockwise) using the remaining wrench (G) Fig. 12.
6.Replace table insert (A) Fig. 13, making certain that it is flush with table surface and rubber washer is in place.
7.Place a straight edge or square (H) Fig. 13, on the saw table extending over the table insert (A) as shown. If an adjustment is necessary, tighten or loosen the two adjustment screws (K).
F L
E
D
B 
A
L
Fig. 11
F
C
D
E
G
Fig. 12
H
K
A
K
Fig. 13
11