DeWalt 36-600 instruction manual Assembling Blade Guard and Splitter Assembly

Page 15

ASSEMBLING BLADE GUARD AND SPLITTER ASSEMBLY

1. WARNING: WHEN ASSEMBLING THE BLADE GUARD AND SPLITTER ASSEMBLY, MAKE CERTAIN THE TOOL IS DISCONNECTED FROM THE POWER SOURCE.

2.Assemble splitter bracket (A) to the end of the guard support rod using the two hex nuts and flat washers (B), as shown in Fig. 26.

3.Assemble the blade guard and splitter assembly (C) to the splitter bracket (A) using the hex head screw, star washer and flat washer (D) Fig. 27, and wing nut, star washer and flat washer (E) Fig. 28.

4.NOTE: Make certain the two protrusions, “pins” (F) Fig. 28, are engaged with the channel of the splitter assembly (C) before tightening wing nut (E).

5.Check the alignment of the splitter (C) Fig. 29, to the saw blade using a straight edge as shown. If alignment is necessary, loosen nut (B), align splitter (C) and retighten nut (B).

C

F

E

Fig. 28

A

B B

Fig. 26

D

CA

Fig. 27

C

C

B

Fig. 29

15

Image 15
Contents Table Saw Always Wear EYE Protection Safety RulesAdditional Safety Rules For Table Saws Grounding Instructions Connecting Tool to Power SourcePower Connections Motor SpecificationsMinimum Gauge Extension Cord Extension CordsUnpacking and Cleaning For Rear Guide Rail For Saw Stand Assembly Instructions Assembling StandAssembling SAW To Stand Assembling Extension Wings Assembling Blade Raising and Tilting HandwheelsAssembling SAW Blade E D Assembling Guide RailsAssembling RIP Fence Leveling and Adjusting Front Guide Rail Assembling Blade Guard and Splitter Assembly Operating Controls and Adjustments Assembling RIP Fence to Guide Rails Adjusting 90 and 45 Degree Positive StopsRIP Fence Operation and Adjustments Adjusting Table Insert Miter Gage Operation and AdjustmentsRipping CROSS-CUTTINGCutterhead in a Bevel Position Using Accessory Moulding CutterheadUsing Accessory Dado Head Constructing a Featherboard Using Auxiliary Wood Facing on RIP FenceConstructing a Push Stick Push StickChanging the Blade Brush Inspection ReplacementDisconnect the Tool from the Power Source Belt ReplacementAccessories Page Canadian PORTER-CABLE Delta Service Centers