DeWalt 36-600 Using Auxiliary Wood Facing on RIP Fence, Constructing a Featherboard

Page 23

USING AUXILIARY WOOD FACING ON RIP FENCE

It is necessary when performing special operations such as when using the moulding cutterhead to add wood facing (A) Fig. 59, to one or both sides of the rip fence, as shown. The wood facing is attached to the fence with wood screws through the holes provided in the fence. 3/4 inch stock is suitable for most work although an occasional job may require 1 inch facing.

A wood facing should be used when ripping thin material such as paneling to prevent the material from catching between the bottom of the rip fence and the saw table surface.

At a slight charge, further information on the safe and proper operation of table saws is available in the Delta “Getting the Most Out of Your Table Saw” How-To Book, Catalog No. 11-400. Additional information on table saw safety is also available by writing to:

National Safety Council

1121 Spring Lake Drive

Itasca, IL 60143-3201

A

Fig. 59

CONSTRUCTING A FEATHERBOARD

Fig. 60 illustrates dimensions for making a typical featherboard. The material which the featherboard is constructed of, should be a straight piece of wood that is free of knots and cracks. Featherboards are used to keep the work in contact with the fence and table and help prevent kickbacks. Clamp the featherboards to the fence and table so that the leading edge of the featherboards will support the workpiece until the cut is completed. An 8" high flat board can be clamped to the rip fence and the featherboard can be clamped to the 8″ high board. Use featherboards for all non “thru-sawing” operations where the guard and splitter assembly must be removed. Always replace the guard and splitter assembly when the non thru-sawing operation is completed.

Fig. 60

23

Image 23
Contents Table Saw Always Wear EYE Protection Safety RulesAdditional Safety Rules For Table Saws Grounding Instructions Connecting Tool to Power SourcePower Connections Motor SpecificationsMinimum Gauge Extension Cord Extension CordsUnpacking and Cleaning For Rear Guide Rail For Saw Stand Assembling SAW To Stand Assembly InstructionsAssembling Stand Assembling Extension Wings Assembling Blade Raising and Tilting HandwheelsAssembling SAW Blade E D Assembling Guide RailsAssembling RIP Fence Leveling and Adjusting Front Guide Rail Assembling Blade Guard and Splitter Assembly Operating Controls and Adjustments Assembling RIP Fence to Guide Rails Adjusting 90 and 45 Degree Positive StopsRIP Fence Operation and Adjustments Adjusting Table Insert Miter Gage Operation and AdjustmentsRipping CROSS-CUTTINGCutterhead in a Bevel Position Using Accessory Moulding CutterheadUsing Accessory Dado Head Constructing a Featherboard Using Auxiliary Wood Facing on RIP FenceConstructing a Push Stick Push StickChanging the Blade Brush Inspection ReplacementDisconnect the Tool from the Power Source Belt ReplacementAccessories Page Canadian PORTER-CABLE Delta Service Centers