DeWalt 36-600 instruction manual Leveling and Adjusting Front Guide Rail

Page 14

LEVELING AND ADJUSTING FRONT GUIDE RAIL

1.MAKE CERTAIN THE TOOL IS DISCONNECTED FROM THE POWER SOURCE. Raise saw blade to its highest level.

2.With handle (A) Fig. 22 in the raised position, place rip fence (B) on the saw table as shown. NOTE: Make certain rip fence (B) is engaged on rear guide rail (C). Move rip fence (B) against saw blade as shown in Fig. 23.

3.Carefully move front guide rail (D) Fig. 23, left or right as needed until line on cursor (E) aligns with zero (“0”) on guide rail scale (F). Push handle (A) downward to lock rip fence in position. Snug up front guide rail mounting hardware. Minor adjustment to the cursor (E) Fig. 24 can be made by loosening two screws (G), adjusting cursor left or right, and tightening two screws (G). Remove rip fence and lower saw blade.

4. Using a square (H) Fig. 25 set at 13/16″, place the

square on the saw table and against the top of guide rail

(D). Align the guide rail until it is parallel to the saw table

by loosening and tightening mounting hardware at five

positions (K) Fig. 25.

B

A

Fig. 22

E

F

A

Fig. 23

G

E

Fig. 24

D H

C

D

5. Check the guide rail adjustment again to make certain

the rip fence is aligned with the guide rail scale.

K

K

Fig. 25

14

Image 14
Contents Table Saw Safety Rules Always Wear EYE ProtectionAdditional Safety Rules For Table Saws Motor Specifications Connecting Tool to Power SourcePower Connections Grounding InstructionsExtension Cords Minimum Gauge Extension CordUnpacking and Cleaning For Rear Guide Rail For Saw Stand Assembling SAW To Stand Assembly InstructionsAssembling Stand Assembling Blade Raising and Tilting Handwheels Assembling Extension WingsAssembling SAW Blade Assembling Guide Rails E DAssembling RIP Fence Leveling and Adjusting Front Guide Rail Assembling Blade Guard and Splitter Assembly Operating Controls and Adjustments Adjusting 90 and 45 Degree Positive Stops Assembling RIP Fence to Guide RailsRIP Fence Operation and Adjustments Miter Gage Operation and Adjustments Adjusting Table InsertCROSS-CUTTING RippingUsing Accessory Moulding Cutterhead Cutterhead in a Bevel PositionUsing Accessory Dado Head Using Auxiliary Wood Facing on RIP Fence Constructing a FeatherboardPush Stick Constructing a Push StickBrush Inspection Replacement Changing the BladeBelt Replacement Disconnect the Tool from the Power SourceAccessories Page Canadian PORTER-CABLE Delta Service Centers