TWO YEAR TOOL LIMITED WARRANTY
Every MILWAUKEE tool is tested before leaving the factory and is warranted to be free from defects in material and workmanship. MILWAUKEE will repair or replace (at MILWAUKEE’s discretion), with- out charge, any tool (including battery chargers) which examination proves to be defective in material or workmanship from two (2) years after the date of purchase. Return the tool and a copy of the purchase receipt or other proof of purchase to a MILWAUKEE Factory Service/ Sales Support Branch location or MILWAUKEE Authorized Service Sta- tion, freight prepaid and insured. This warranty does not cover damage from repairs made or attempted by other than MILWAUKEE authorized personnel, abuse, normal wear and tear, lack of maintenance, or accidents.
Battery Packs, Flashlights, and Radios are warranted for one (1) year from the date of purchase.
THE REPAIR AND REPLACEMENT REMEDIES DESCRIBED HEREIN ARE EXCLUSIVE. IN NO EVENT SHALL MILWAUKEE BE LIABLE FOR ANY INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES, INCLUDING LOSS OF PROFITS.
THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRAN- TIES, OR CONDITIONS, WRITTEN OR ORAL, EXPRESSED OR IMPLIED FOR MERCHANTABLILITY OR FITNESS FOR PARTICULAR USE OR PURPOSE.
This warranty gives you specific legal rights. You may also have other rights that vary from state to state and province to province. In those states that do not allow the exclusion of implied warranties or limitation of incidental or consequential damages, the above limitations or exclu- sions may not apply to you. This warranty applies to the United States, Canada, and Mexico only.
page 8
ACCESSORIES
WARNING!
To reduce the risk of injury, always unplug the tool before attaching or removing accessories. Use only specifically recommended accesso- ries. Others may be hazardous.
For a complete listing of accessories refer to your MILWAUKEE Electric Tool catalog or go
8'
Cat. No.
25'
Cat. No.
Offset Blade Adapter
Select Models (Fig. 7)
Cat. No.
An offset blade adapter is available to make flush cuts possible. To attach, remove blade clamping screw and blade clamp. Place adapter over spindle, lining up hole in adapter casting with threaded hole in spindle. Replace screw, attaching adapter to spindle. Blade can then be secured in adapter blade clamp in the same manner it was secured in the spindle clamp.
Fig. 7
Select Models:
Blade Clamp
Cat. No.
Blade Clamp Screw
Cat. No.
“787” Blades:
Blade Clamp
Cat. No.
Blade Clamp Screw
Cat. No.