Hitachi 231327 manual Field & Wiring Harness, Clamp

Field & Wiring Harness

NOTE: Refer to Fig. 13.

1.Loosen the four setscrews (12) holding the field (6) to the clutch housing (2).

2.Pull off the field.

3.Pull the plastic caps (B) off the wire screws (98) in both places on the field. Loosen the screws and release the wires (96).

4.Skip ahead to Reassembly, page 24, step 4. or continue on page 21.

12

2

6

96

B

Fig. 13	98
	03479

Clamp

NOTE: A standard steering wheel puller and two

1/4–28 x 3 or 4 in. long screws are required to remove the clamp.

NOTE: Refer to Fig. 14.

1.Loosen the two screws (16) on the clamp (3), working through the slot at the bottom of the clutch housing (2).

2.Install two screws (B) of the tool (A) in two of the threaded holes in the clamp (3). Tighten the screw

(C)until the clamp comes off.

3.Skip ahead to Reassembly, page 24, step 3., or continue to the right.

2

A

B

C

Fig. 14

3

16

03480

308398 21