Engine
1.Remove the Pinion Housing, Clutch, Field and Wiring Harness, Clamp and Clutch Housing, as instructed on pages 18 and 20 through 22.
2.See Fig. 16 and17. Disconnect the red wire from the engine lead (B). Disconnect the black and white wires from the field. Loosen the clamp (97). Pull the wires carefully through the grommets (66) before removing the engine. Remove the two locknuts (111) and then pull the screws (14) out of the base of the engine.
3.Lift the engine carefully and place it on a work bench.
4.Skip ahead to Reassembly, page 24, step 1.
NOTE: All service to the engine must be performed by an authorized HONDA dealer.
1To the field.
2To the engine.
66
1 WHITE
2
B
14
66
A |
Ref 15 80, 99
BLACK
97
118
Fig. 16
66
2
B
RED
97
03478A
15 | 111 |
|
Fig. 17 | 03477C |
|
308398 23