Graco 3A2587H important safety instructions Model Voltage Description

Page 1

Operation - Repair - Parts

Electric Hand-Held Paint Sprayers

3A2587H

 

 

EN

 

 

- For portable spray applications of architectural paints and coatings only -

- Not approved for use in explosive atmosphere locations -

IMPORTANT SAFETY INSTRUCTIONS Read all warnings and instructions in this

manual. Save these instructions.

All Models:

Maximum Working Pressure 2000 psi (14 MPa, 138 bar)

Model

Voltage

Description

 

 

 

16N658

120V

Fixed Pressure

16N659

 

 

16N673

120V

Adjustable Pressure

17C810

 

 

Adjustable Pressure

Fixed Pressure

Adjustable Pressure

ti18910a

WARNING

Use only water-based or oil-based (mineral spirit-type) materials with flash point greater than 100° F (38° C). Do not use materials which state “FLAMMABLE” on the packaging. For more information about your material, request MSDS from distributor or retailer.

Use oil-based materials outdoors or in a well-ventilated indoor area with a flow of fresh air.

Image 1
Contents Model Voltage Description Adjustable Pressure Fixed PressureTable of Contents Extension Cords GroundingExtension Cord Gauge Extension Cord Length AWG Minimum Electric Shock Hazard Fire and Explosion HazardSkin Injection Hazard Pressurized Aluminum Parts Hazard Equipment Misuse HazardMoving Parts Hazard Toxic Fluid or Fumes HazardComponent Identification Power Cord Using Electrical CordsGrounding and Electrical Requirements Extension Cord RequirementsTrigger Lock Pressure Relief ProcedurePrime/Spray Valve Trigger LockedPressure Control Knob Reversible Spray TipFlexible Suction Tube Not available on all unitsOverheating Protection Sprayer SetupIf sprayer fails to prime, try one of the steps below Starting a New Job Or Refilling the Material CupChoosing the Correct Tip Choosing Pressure Control Knob SettingUnderstanding Tip Number Selecting Tip Hole SizeGetting Started with Basic Techniques Install Spray Tip/Guard Assembly if not installedTriggering Sprayer Aiming Sprayer Unclogging Spray Tip/Guard AssemblySpray Pattern Quality Flushing Sprayer Shutdown and CleaningTi15529ati18926a Storage Cleaning Sprayer ExteriorModels 16N658, 16N659, 16N673, 17C810 Replacement PartsDescription Parts List Models 16N658, 16N659, 16N673, 17C810Model 16N659, 16N673, 17C810 16M873 Installation Inlet Valve Fitting Removal/ServiceRemoval Outlet Valve Fitting RepairWiring General ServiceProblem Cause Solution TroubleshootingMaterial Spray Pattern DiagnosticsSee Shutdown and Cleaning, Problem Cause Solution Troubleshooting LeaksHand-Held Sprayer Models 16N673, 16N659 Metric Technical DataHand-Held Sprayer Model 16N658 Metric Date Material Spray Pressure Setting Preferred Material Settings LogExample Mark Dial3A2587H Graco Information Graco Standard Warranty