Graco 3A2587H Technical Data, Hand-Held Sprayer Models 16N673, 16N659 Metric

Page 28

Technical Data

Technical Data

Hand-Held Sprayer (Models: 16N673, 16N659)

	U.S.	Metric

Adjustable Pressure Range	1000 - 2000 psi	7 - 14 MPa, 69 - 138 bar

Maximum Amperage	4 Amps	4 Amps

Weight	6.04 lb	2.74 kg

Dimensions:

Length	12.75 in.	32.4 cm

Width	5.5 in.	14.0 cm

Height	10.75 in.	27.3 cm

Storage Temperature Range 	32° to 113° F	0° to 45° C

Operating Temperature Range 	40° to 90° F	4° to 32° C

Storage Humidity Range	0% to 95% relative humidity,	0% to 95% relative humidity,
	non-condensing	non-condensing

Sound Pressure Level	70.5 dBa† (for sound power level, add 81.5 dBa)

Vibration Level Acceleration	Less than 2.2 feet/s2	Less than 0.67 m/s2††
Power Cord	18 AWG, 3-wire, 18 in.	1.0 mm2, 3-wire, 46 cm
Electrical Power Requirement	120 Vac, 60 Hz, 15A, 1 phase

Pump damage will occur if fluid freezes in pump.

Damage to plastic parts may result if impact occurs in low temperature conditions.

Changes in paint viscosity at very low or very high temperatures can affect sprayer performance.

† per ISO 3744 measured at 3.3 feet (1m) †† per ISO 5349, no load condition

28

3A2587H

Image 28

Contents Adjustable Pressure Fixed Pressure Model Voltage DescriptionTable of Contents Extension Cords GroundingExtension Cord Gauge Extension Cord Length AWG Minimum Electric Shock Hazard Fire and Explosion HazardSkin Injection Hazard Equipment Misuse Hazard Pressurized Aluminum Parts HazardMoving Parts Hazard Toxic Fluid or Fumes HazardComponent Identification Using Electrical Cords Power CordGrounding and Electrical Requirements Extension Cord RequirementsPressure Relief Procedure Trigger LockPrime/Spray Valve Trigger LockedReversible Spray Tip Pressure Control KnobFlexible Suction Tube Not available on all unitsSprayer Setup Overheating ProtectionStarting a New Job Or Refilling the Material Cup If sprayer fails to prime, try one of the steps belowChoosing Pressure Control Knob Setting Choosing the Correct TipUnderstanding Tip Number Selecting Tip Hole SizeGetting Started with Basic Techniques Install Spray Tip/Guard Assembly if not installedTriggering Sprayer Aiming Sprayer Unclogging Spray Tip/Guard AssemblySpray Pattern Quality Shutdown and Cleaning Flushing SprayerTi15529ati18926a Cleaning Sprayer Exterior StorageReplacement Parts Models 16N658, 16N659, 16N673, 17C810Parts List Models 16N658, 16N659, 16N673, 17C810 DescriptionModel 16N659, 16N673, 17C810 16M873 Inlet Valve Fitting Removal/Service InstallationOutlet Valve Fitting Repair RemovalGeneral Service WiringTroubleshooting Problem Cause SolutionSpray Pattern Diagnostics MaterialSee Shutdown and Cleaning, Troubleshooting Leaks Problem Cause SolutionTechnical Data Hand-Held Sprayer Models 16N673, 16N659 MetricHand-Held Sprayer Model 16N658 Metric Preferred Material Settings Log Date Material Spray Pressure SettingExample Mark Dial3A2587H Graco Standard Warranty Graco Information