Graco 3A2587H important safety instructions Storage, Cleaning Sprayer Exterior

Page 17

Cleaning Sprayer Exterior

•Wipe paint off outside of sprayer using a soft cloth moistened with water or flushing fluid. Do NOT submerge the sprayer. Do NOT use solvents with a flash point greater than 100° F (38° C).

ti18922a

Storage

NOTICE

Failure to store sprayer with Pump Armor will result in operational problems the next time you spray. Always circulate Pump Armor through the sprayer after clean- ing. Water or solvents other than mineral spirits left in the sprayer will corrode and damage the pump.

1.Lift valve UP to the prime position. Remove material cup and flexible suction tube.

ti16700a

ti19034a ti18916a

2.Remove child-resistent cap. Thread nozzle onto Pump Armor bottle.

NOTE: For best results, make sure bottle is full.

ti18067a

Storage

3. Hold sprayer upside-down over a waste container.

ti19424a

4.Insert Pump Armor nozzle over material inlet and push firmly until it stops. Squeeze cleaning bottle until Pump Armor flows out drain tube.

ti18066a

ti16700a

5.Remove Pump Armor nozzle and replace child-resistent cap and tighten securely for storage.

ti18069a

6.Attach flexible suction tube and material cup. Push valve DOWN to spray position.

ti16701a

ti19423a	ti18915a

7.Store sprayer indoors in a cool, dry place. Store in an upright position only. Never store sprayer with material in the cup.

ti18921a

3A2587H

17

Image 17

Contents Model Voltage Description Adjustable Pressure Fixed PressureTable of Contents Extension Cord Gauge Extension Cord Length AWG Minimum GroundingExtension Cords Skin Injection Hazard Fire and Explosion HazardElectric Shock Hazard Pressurized Aluminum Parts Hazard Equipment Misuse HazardMoving Parts Hazard Toxic Fluid or Fumes HazardComponent Identification Power Cord Using Electrical CordsGrounding and Electrical Requirements Extension Cord RequirementsTrigger Lock Pressure Relief ProcedurePrime/Spray Valve Trigger LockedPressure Control Knob Reversible Spray TipFlexible Suction Tube Not available on all unitsOverheating Protection Sprayer SetupIf sprayer fails to prime, try one of the steps below Starting a New Job Or Refilling the Material CupChoosing the Correct Tip Choosing Pressure Control Knob SettingUnderstanding Tip Number Selecting Tip Hole SizeTriggering Sprayer Install Spray Tip/Guard Assembly if not installedGetting Started with Basic Techniques Spray Pattern Quality Unclogging Spray Tip/Guard AssemblyAiming Sprayer Flushing Sprayer Shutdown and CleaningTi15529ati18926a Storage Cleaning Sprayer ExteriorModels 16N658, 16N659, 16N673, 17C810 Replacement PartsDescription Parts List Models 16N658, 16N659, 16N673, 17C810Model 16N659, 16N673, 17C810 16M873 Installation Inlet Valve Fitting Removal/ServiceRemoval Outlet Valve Fitting RepairWiring General ServiceProblem Cause Solution TroubleshootingMaterial Spray Pattern DiagnosticsSee Shutdown and Cleaning, Problem Cause Solution Troubleshooting LeaksHand-Held Sprayer Models 16N673, 16N659 Metric Technical DataHand-Held Sprayer Model 16N658 Metric Date Material Spray Pressure Setting Preferred Material Settings LogExample Mark Dial3A2587H Graco Information Graco Standard Warranty