Graco 258870, 258875, 258866. 258863. 3A0159E important safety instructions Technical Data, Sprayer

Page 25

Technical Data

Technical Data

Sprayer:

Maximum working pressure	2000 psi (137.8 bar, 13.7 MPa)

Maximum amperage	4 amps

Weight	5.89 lb (2.67 kg)

Dimensions:

Length	13.25 in. (33.6 cm)

Width	5.0 in. (12.7 cm)

Height	10.75 in. (27.3 cm)

Storage temperature range ◆❖	32° to 122°F (0° to 50°C)

Operating temperature range ✔	40° to 90° F (4° to 32°C)

Storage Humidity Range	0% to 95% relative humidity, non-condensing

Duty Cycle	50%

Power Cord	18 AWG, 3-wire, 18 in. (46 cm)

Electrical Power Requirement	120 Vac, 60 Hz, 15A, 1 phase

◆Pump damage will occur if fluid freezes in pump.

❖Damage to plastic parts may result if impact occurs in low temperature conditions.

✔Changes in paint viscosity at very low or very high temperatures can affect sprayer performance.

3A0159E

25

Image 25

Contents 3A0159E Table of Contents Extension Cord Gauge Extension Cord Length Extension CordsFire and Explosion Hazard Equipment Misuse Hazard TrueCoat Component Identification TrueCoat Plus Component Identification Power Cord Using Electrical CordsGrounding and Electrical Requirements Extension Cord RequirementsTrigger Lock Pressure Relief ProcedureControl Lever Position Installing Suction Tube SetupCleanup/Storage Overheating ProtectionSprayer Setup Starting a New Job or Refilling the Cup MaterialsReversible Tip Selection Chart Shoulder Strap InstallationThin Medium Heavy Aiming Sprayer Triggering SprayerUnclogging Spray Tip/Guard Assembly Flushing Sprayer Shutdown and CleaningTi14991a Storage Cleaning Sprayer ExteriorTips Ref. Part Replacement Parts and KitsPart Problem Cause Solution TroubleshootingSpray Pattern Diagnostics Problem Cause Solution See Shutdown and Cleaning, See Reversible Tip Selection ChartSee Install Tip/Guard Assembly, Alternate Priming Method Installation Inlet Valve CleaningRemoval Sprayer Technical DataTechnical Data Technical Data 3A0159E Graco Information Graco Standard Warranty