Graco 258866. 258863. 3A0159E, 258875, 258870 important safety instructions Sprayer Setup

Setup

Sprayer Setup

This sprayer arrives from the factory with a small amount of test material in the system. It is important that you flush this material or any storage fluid from the sprayer before using it.

1.Plug sprayer into a properly-grounded outlet.

2.Fill material cup with water and thread onto sprayer.

3.Put control lever to UP position, then hold trigger in for 10 seconds.

4. Put control lever DOWN to spray position.

5.Reverse spray tip to UNCLOG position and trigger sprayer into a waste area.

6.Engage trigger lock and put control lever UP to release pressure.

ti14999a

7. Unscrew and remove material cup.

8.Disengage trigger lock, put control lever DOWN, hold sprayer slightly above material cup, and pull trigger to discharge fluid from pump.

9. Discard material in the cup.

3A0159E 11