Graco Inc 313384B, 257030 Material Flow Adjustment, Air Flow Adjustment, For Continuous Spraying

Page 15

Material Flow Adjustment

B

ti4339a

For a lighter spray pattern, decrease material pres- sure at sprayer.

For a heavier spray pattern, increase material pres- sure at sprayer.

Air Flow Adjustment

23

TI

Trigger gun.

To decrease air flow, close air valve (23) clockwise.

To increase air flow, open air valve (23) coun- ter-clockwise.

System Adjustment

NOTE: Keep a small amount of air flowing through air line and gun tip to prevent material from backing up needle.

Preventing Material Surge at Gun Trigger

Pressure will build up in system when not triggering gun. To prevent material surge at beginning of spray pattern:

Point gun away from surface to be sprayed when trigger is first pulled.

Hold gun away from surface and gradually bring gun to surface.

Trigger gun as little as possible.

For Continuous Spraying

D

ti4006a

Engage trigger lock (D) to hold trigger open and reduce fatigue.

313384B

15

Image 15
Contents Repair Related ManualsFire and Explosion Hazard 313384B Component Identification Component Identification List Pressure Relief Procedure Setup Removing and Installing HopperPreparation Additional Equipment Needed Installing Hopper GWetting Hose Waste Wetting SystemWater Mixing MaterialOperation Characteristics Application Nozzle Orifice† Nozzle Number Air Volume‡ Spray TechniquesNozzle Selection System Adjustment For Continuous Spraying Material Flow AdjustmentAir Flow Adjustment Preventing Material Surge at Gun TriggerShutdown and Cleanup After SprayingRelieve Pressure , Maintenance Technical DataComponent Task Frequency Graco Information Graco Standard Warranty