Graco Inc 313384B, 257030, 2000EX important safety instructions

Page 3

PLASTIC PARTS CLEANING SOLVENT HAZARD

Use only compatible water-based solvents to clean plastic structural or pressure-containing parts. Many solvents can degrade plastic parts and cause them to fail, which could cause serious injury or property damage. See Technical Data in this and all other equipment instruction manuals. Read fluid and solvent manufacturer’s warnings.

PERSONAL PROTECTIVE EQUIPMENT

You must wear appropriate protective equipment when operating, servicing, or when in the operating area of the equipment to help protect you from serious injury, including eye injury, inhalation of toxic fumes, burns, and hearing loss. This equipment includes but is not limited to:

Protective eye wear

Clothing and respirator as recommended by the fluid and solvent manufacturer

Gloves

Hearing protection

NOTICE

Water or material remaining in unit when temperatures are below freezing can damage pump and/or delay startup.

To insure water and material are completely drained out of unit:

1.Remove material line from sprayer.

2.Tip sprayer to allow material (water) to flow out of pump inlet.

Before adding material or starting unit in cold weather, run warm water through pump.

313384B

3

Image 3
Contents Repair Related ManualsFire and Explosion Hazard 313384B Component Identification Component Identification List Pressure Relief Procedure Setup Removing and Installing HopperPreparation Additional Equipment Needed Installing Hopper GWetting Hose Waste Wetting SystemWater Mixing MaterialOperation Characteristics Application Nozzle Orifice† Nozzle Number Air Volume‡ Spray TechniquesNozzle Selection System Adjustment For Continuous Spraying Material Flow AdjustmentAir Flow Adjustment Preventing Material Surge at Gun TriggerShutdown and Cleanup After SprayingRelieve Pressure , Maintenance Technical DataComponent Task Frequency Graco Information Graco Standard Warranty