Graco Inc 257030, 313384B, 2000EX Setup, Preparation, Removing and Installing Hopper

Page 7

Setup

Preparation

1.Connect air and material hoses to gun. Tighten securely.

Setup

Removing and Installing Hopper

Hopper (G) can be removed from cart for cleaning and when using Siphon Kit 248112 (available from Graco distributor).

Removing Hopper (G)

1.Push down 2 latches on each side of hopper cou- pler (H).

23

ti3899a

ti4003a

2.Connect one end of material hose (cc) to material outlet (K or L) and other end to gun material inlet (bb).

NOTE: Material plug must be installed in material outlet (K or L) you are not using.

2. Lift hopper (G) straight up off of unit.

K

L

cc

ti3778b

dd

N

ti3900a

3. Open gun air valve (23).

313384B

7

Image 7
Contents Repair Related ManualsFire and Explosion Hazard 313384B Component Identification Component Identification List Pressure Relief Procedure Removing and Installing Hopper SetupPreparation Additional Equipment Needed Installing Hopper GWetting Hose Waste Wetting SystemWater Mixing MaterialOperation Characteristics Spray Techniques Application Nozzle Orifice† Nozzle Number Air Volume‡Nozzle Selection System Adjustment For Continuous Spraying Material Flow AdjustmentAir Flow Adjustment Preventing Material Surge at Gun TriggerAfter Spraying Shutdown and CleanupRelieve Pressure , Technical Data MaintenanceComponent Task Frequency Graco Information Graco Standard Warranty