Graco Inc 257030, 313384B, 2000EX Shutdown and Cleanup, After Spraying, Relieve Pressure

Page 16

Shutdown and Cleanup

Shutdown and Cleanup

NOTICE

Turn off sprayer if you are going to stop spraying for 5 minutes or longer.

Before removing material hose, Relieve Pressure and make sure there is no material inside of hose.

To keep sprayer in good operating condition, always clean it thoroughly and prepare it properly for storage.

If water freezes in sprayer, damage may occur. During cold weather, store sprayer where it will not freeze.

Spray water into waste bucket to empty material hopper.

NOTE: A soft brush can be used to loosen dried-on material.

After Spraying

1. Relieve Pressure, page 6.

4. Follow Pressure Relief, page 6.

2.Fill material hopper with 2 - 4 gallons of clean water.

3.Spray inside material hopper to circulate water through gun and hose. While circulating water, use gun to clean material hopper.

16

313384B

Image 16
Contents Related Manuals RepairFire and Explosion Hazard 313384B Component Identification Component Identification List Pressure Relief Procedure Removing and Installing Hopper SetupPreparation Installing Hopper G Additional Equipment NeededWetting Hose Wetting System WasteMixing Material WaterOperation Characteristics Spray Techniques Application Nozzle Orifice† Nozzle Number Air Volume‡Nozzle Selection System Adjustment Material Flow Adjustment Air Flow AdjustmentPreventing Material Surge at Gun Trigger For Continuous SprayingAfter Spraying Shutdown and CleanupRelieve Pressure , Technical Data MaintenanceComponent Task Frequency Graco Standard Warranty Graco Information