Installation
Installation
The Automatic AirPro spray gun can spray most coatings or finishes currently being used for automotive, industrial, aerospace, marine, wood, plastic and architectural applications, while easily operating from paint delivery sys- tems, such as pressure pots or remote pumps for production line operation.
The air regulator must have a minimum air flow capacity of 30 scfm at 100 psi (0.7 MPa, 7.0 bar) air pressure.
Ventilate Spray Booth
•Check and follow all national, state, and local codes regarding air exhaust velocity requirements.
•Check and follow all local safety and fire codes.
Configure Gun and Manifold
The gun is supplied with an internal fluid plug and seals (19, 20, 21). To use the gun in a cir- culating system, remove the internal plug. In a
Circulating System
1.Apply
2.Install the elbows (107) in both fluid ports of the manifold (101).
3.Connect the fluid supply line to one elbow and the fluid return line to the other. The manifold fluid ports are reversible.
4.Install the gun on the manifold, using the four screws (13). Start the threads of all four screws. Tighten the front two screws first, and then tighten the back two. Torque all four screws evenly to 65
Non-circulating System
1.See FIG. 1. Apply
2.Install an elbow (107) in one fluid port of the manifold (101), and a plug (109) in the other port.
3.Install the internal plug (19) in the gun fluid port on the same side as the manifold plug.
4.Connect the fluid supply line to the fluid inlet elbow (107).
5.Install the gun on the manifold, using the four screws supplied. Start the threads of all four screws. Tighten the front two screws first, and then tighten the back two. Torque all four screws evenly to 65
1Remove when used in circulating systems.
2Replace with elbow (107) when used in circulating systems.
21
20 |
101
1 19
107
2 109
ti8587b
FIG. 1: Non-Circulating Setup Shown (cutaway view)
10 | 313516C |